Separate names with a comma.
Did you notice any improved harmonics? Anything noticeably different about the way bearings and associated parts wear?
any one notice less harmonics in their engine?
make sure you put a balistic blanket and or a scatter shield on that torque flight. Some of the nastiest tranny explosions that I have even seen...
anyone ever run the C&A deep cycle rods? How many runs are they good for?
how often do you change out your rods? Seems that pulling them down every run would shorten their cycle life? Do you cycle out rod bolts between...
how often do you guys check them?
I just took a look at the video and it looked like the car was pourposing up and down at the hit of the throttle. From the tire wrap it looks like...
then the one sensor would have a branch in it right? Maybe the rules should state that any drive shaft, clutch or any other 'speed' sensor used...
The traction control needs an input if it is hidden or not right? Is it possible to use the same driveshaft sensor or is an additional one...
Good is a realitive statement. Could you possibly post the picturr along with your incremental numbers?
Is it possible that he is hitting the limiter in low gear? The lack of MPH 5.35 @ 252, makes me think that they are running a 4.56 gear to 60'...
pretty sure it has to stay inside the rails. Not sure if it is really a rule or not but I had a buddy that ran TAD with his KB olds and they would...
hey, thanks again for the reply. This truely is a great site! I have more pressure at the pump then post barrel valve. I have pressure sensors at...
I am assuming that you are talking about the pressure post barrel valve at the nozzles and not at the pump correct? I just wanted to make sure...
I am using a low gear leanout. I have a series of valves and can open them anyway I like. On the 5.80 pass I had two open, one closing at the 1-2...
Thanks for the reply. I haven't pulled the crank yet to check the mains. I have been busy here with work. I would think that if there was too much...
The four nozzles in the case is what I refer to as 'hat nozzles'. I guess that I should be more clear since we are talking about actually...
it is a dragster
You could always install a spacer. Most of the ones that I have seen are the billet injectors with the holes already built in. Just out of...
I have been low 5.80's at 231 with the current combo. The last run I bumped the timing up to 30* from 25. no other changes, a sliver of aluminum...
