Separate names with a comma.
X2 an update would be nice. I would like to buy a set of rods that I don't have to re-balance.
Just thinking out loud. I would be curious to see the results. Keep us posted and thanks for the good data.
pressure regulated high speed Has anyone tried the Kinsler style high speed diaphragm bypass? I am just curious if there would be a flow and/or...
Thanks for the update, this will save someone some headaches in the future. Are you planning on moving the high speed back around to the way it...
Thanks for the good, hard info. I tried to send you a PM but your inbox is full.
Are you going to have blower/transmission rules or is this going to be run what you brung kind of deal with the index?
You have a PM
Does anyone use the air operated valves on the back side of the barrel valve? All of the diagrams that I have seen (like the PSI stuff) takes the...
What is the difference between the B and the D series if they both have the same amount of cid/rev? Are the placement of the hat nozzles different?
does it matter where you put the main jet? I was looking through a few diagrams from Gorr and the one with the square enderle they had a 'high...
I have another question along the same line. I have seen some fuel systems in the past that have the idle popet located down near the pump on the...
Just for the record it was the words 'simple hydralic system' that broke it wide open for me. Sometimes I get so wrapped up with other things I...
Thanks to all for the replies. Mr. Canter if I offended you I am sorry. I enjoy your input as well as others. I did not mean to pick a fight with...
Maybe another fuel injection guru will chime in with an explanation. Have you ever checked the pressure in the high speed return line? By taking...
I am talking about the fuel has to flow through the orfice (a restriction) before it can start to apply pressure to the popet assembly. I am...
I was thinking that there might be some sort of pressure drop across the orifice which would slightly delay the opening of the high speed and that...
I have used the 4 link calculator from Jerry Bickel in the past. Simple to use once you get all your measurements.
Why would you go with a wider LSA?
I don't think that I would o-ring the block or heads. I would much rather push out a head gasket then crack a block or blow a rod. Seems that you...
If I change the jet in the high speed assembly will it affect the opening pressure of the popet? When I check the cracking pressure should I check...
