Separate names with a comma.
I raced against Tim a few times in Douglas Wyoming years ago, very nice guy. I am sad to hear this news.
I set mine at zero, 2 thou at most. Otherwise you will have variations in timing.
ohms With an ohm meter, one lead on one of the top terminals, and the other on the coil wire terminal, you should get about 14.5 ohms when new....
Good point Randy I totally agree with Randy Goodwin. We used to pull all the way down from Edmonton to Vegas every year for the divisional...
I believe that rev limiting the motor on the line at 8 grand doesn't help either. I also agree with others that rods need to be replaced every 30...
I am so sorry to hear this. Norm was such a gentle man, it was always a pleasure to talk to him. I have raced against/with Norm since the early...
Thanks Eli, I think. I have to modify the procedure though, due to recent bad experiences. From now on I am going to check the cam timing after...
I just talked to Hoosier, because I was concerned about running the tires on our nostalgia nitro funny car. They also have the C2055 number on...
The reason for putting it behind the barrel valve is to allow the motor to run rich at the launch so it has enough fuel to get through the first...
If you are replacing the inserts anyway, you can weld a piece of threaded rod to the insert, and use it as a slide hammer to pull it out.
I made a spacer for mine that works well. If you are interested, you can either have my dad (George Sitko) do it in California, or if you are in...
Deepest condolences to the Gasparelli Family, from George, Ken, Troy and Nathan Sitko.
We run a lot of marginal tracks, and a few good ones, and find that the Goodyears work very well on good tracks, but not so well on a slippery...
We used it on our TAD for a couple of years, very robust piece. Ports are very small if you buy it new, which is an advantage because you can...
Sometimes after headers have been coated, even if the coating is removed, they are tough to weld. If you find that the area under repair is...
I think you have to keep in mind that it is very difficult to make an alky motor idle nice at low rpm's. I have always found that 1800 to 2000 is...
Not sure exactly what combo you are running, but with our hemi, with a screw blower, we typically run 26 degrees max with an MSD44, we have been...
I know I'm going to get blasted for responding to this, but CowieFan, we all know how great Shawn and Bill and the rest of the guys are running, I...
Impressive day and a career best runner up finish with your A-fuel dragster. Congratulatons Don and crew.
Our team saw the writing on the wall, and got rid of our alky fc, replaced it with a nostalgia nitro fc. At least we're more appreciated and we...
