Separate names with a comma.
1/8 mile door car racing-ET expectations? What do most people use for a rule of thumb on a 2500# door car or ProMod? Many say that 100#s will get...
Answer-----Bad Head Ground I promised several people that I would get back after the next race and report on the dropping cylinders and what I...
Flow Meter Mike, I have a flow meter and I am using different points along the fuel pressure line behind the barrel valve and checking pressures...
4.75gpm 2-step gpm flow Mike, on the 2-step, I have 4.75gpm through the flow meter. I am real close on my tune-up, but want to heat up 2 colder...
2 cold cylinders at launch Trying to idle on the hat, it goes cold on 2 cylinders when at wide open throttle on the 2-step, then takes about 1.4...
Message to Scott in your Inbox-THANK YOU! THANK YOU! Jim
Does anyone know of anyone selling redistribution plates that are being used by some teams between the intake and blower to help even out the...
Shawn, when you were running a Whipple, did you ever run a plate under the blower with different pattern holes to help even out the temperatures...
Blown69camero-Port or Hat Checkvalve? THANK YOU Blown69camero, and that may be where I am having trouble, I just have a poppit or checkvalve on...
On a screw blown alcohol promod hemi motor with a converter, what do most teams set the Checkvalve/poppit to come in at for the port nozzles? We...
Whipple Information That has been a some posts before on here and I think it was when someone asked about the Whipple 980 and someone gave the...
Fuel Curve I have been rich testing the new motor/car combination, but EGTs showed good fuel curve and temps were where I needed to be, and if it...
I Maybe found the fault, but not tested yet???????? We will not run this weekend due to rain, but as I was rewiring today, the ground on the...
Comp ratio is 10.5 to 1 Mike, Compression ratio is 10.5 to 1 and this is a new engine combo with 7 full 1/8 mile passes on it now. The wires are...
New Mag and clean spark plugs I will try a new mag and make sure the plugs are very clean the next run. It looks like we are rained out at...
B9ES NGKs-New MSD wires and New Plugs I have been running B9ES NGKs for several years now with a Roots Blower, a 14-71 Kobelco Superman making 42...
THANK YOU for the help! To Mike and all racers/builders/owners that are trying to help. I have gotten the silicone grease, and even made a gray...
Carbon Tracking down the outside of the plug Mike, new MSD 8.5 wires, a complete set of new wires for every 2 runs with a new coil wire and the...
Carbon Tracking on the Plugs and Cap I should have added earlier that the spark plugs are carbon tracking down the sides and also the cap has...
We are still working our way up to a tune-up for a blown alcohol hemi Promod combination. The problems started at about 50#s boost and now at 55#s...
