Separate names with a comma.
If you lift a blower, do you replace the rods? How about if you have a burst panel, if you blow out the burst panel do you replace the rods?
are 3/8 Comp Cams .080 push rods hi-tech push rods adequate for a BBC blown motor with Comp Cams springs 320# seat pressure?
something I found Here is something I found after my original post, of particular interest was the last paragraph....
In a multi engine modified pulling tractor with blown BBC with 4.5 bore what stroke crank 4.25" or 4.5" would you use.
What does a longer rod length do for a BBC blown engine and how significant is it. Say a .400 long rod verses a 6.700 or 6.800 rod length?
i am first to admit i did not read every post, so if i missed something and this is not relavent then skip it. if you have a 24 volt charger...
going to order a new fire suit, any opinions on RJS fire suits?
what is the name of the business and their website in the mid west that does the promag repair. Electra or something similar?
still lost used the grease filled either side of the spark plug where it looked like it might catch air. I used a used gasket that measures...
grease i was thinking at the time i was using a lot of grease, and i was thinking i allowed for that, but i will do another cylinder and actually...
in the hole ooops .020 i screwed with it with the programs on line. I am not even thinking of the compression ratio at this point, i am just...
Here is my question, where am I loosing the CC. I ordered new pistons gave the manufacturer my motor information, 4.465 bore, 4.25 stroke, chamber...
i use zip ties to hold the bearing in place until i get where i can put the nuts on. to remove them I made a plate with jack bolts that push...
CB743 V CB743 VND CB743 VND-1 CB743 VNDX MB829 V V-10 i am sure i did not put up all available combination's and i might of embellished...
Recently had a block repaired by Billy Leverentz at Oddy's Automotive, I was very happy with the results and wanted to share. The job was done...
if it was mine 5 would be fine,
usage what are you using the crank in, how many rpm's? that clearance sounds fine with 60 wt oil in blown alcohol with 7000 rpm
crank starter I took by blower stater, and made a bracket so it mounted on the crank, and away i went! I just copied a rcd bracket.
here you go it is on this print, if i did not miss what you were looking for....
belt kb olds block aluminum heads 8-71 kobelco k8 at 70% over
