Separate names with a comma.
When figuring your OD I see there are so many pulley combos out there. What is the best way to figure what pulley size to use? I am trying to be...
pulleys I was thinking the same thing. I have 14mm right now and the bottom is like a wagon wheel but it was given to me. I have some 8mm need...
pulleys Screw blower outlaw promodified. Thanks, sean
Which style is the best to run? Thanks, Sean
fuel mgmt Mike, Exactly I meant (gpm) 1 gallon of fuel. And lets say if I was using nos I would enrichen the system by closing the valve....
fuel mgmt I plummed fule mgmt off the main line like Mike said with a tee. So being I am usung the fuel mgmt and lets say I want to pull 1lb of...
fuel mgmt Says you cannot receive any messages?:confused: Thanks, Sean
I have a 4 pole electric fuel log from electromotion. Where is the best place to plumb the fuel inlet? backside of the bv? a return? should I run...
tdc I triple checked myself and came up the same 3 times in a row. I could feel it move past the stop and rotated the motor back and did a 1/4...
tdc So being 30-40 on the crank how does that affect the timing of the motor? So if I set my timing at 28 degrees based off the way I did would...
Hopefully I did this right. I put a piston stop in the #1 hole. Rotated the motor till it started to roll by the stop turned the screw in a little...
jets DMPE has them for 3.75ea which seems to be the best price I have found so far. sean
Where is the best place to buy nozzle jets? Need to buy a good assortment. Thanks, sean
3 phase Do you have 3 legs coming into your box? Sounds like it is hooked on songle pahse if it is slow. Sean
o-ring Yes that is what I am talking about. I never thought of that. I will see what I can find. Thanks dave! Sean
I am trying to dfnd the rubber seal that goes between the blower (screw) to seal the bottom of the blower on the plate it sits on. Appreciate any...
gary, fyi I never got the liners only the tubes. Sean
Is there a rule of thumb to use for percentage drops between gears? Right now I am at 33%. Using a 3 speed. Am I right that if it is to close...
