Separate names with a comma.
Try getting the shake out of the car. Most of your breaking problems should go away. Tire shake is like a bad tune up, it will destroy anything.
Do you still have this program available and if so, which version is it?
Doesn't anybody realize that all Top Fuel cars and most TAD/TAFC cars have traction control? That's we retard timing.
It doesn't matter what top ring style you run. Keep this in mind. When a ring is machined to accept the rail to make it "Gapless", you machine...
I don't have the number off the top of my head, but I think Blower Drive Service has what you need. They are in Whittier, California.
Mike your right. The use of a gapless ring will cause the top ring to unseat from the piston and cylinder wall, losing compression and power.This...
You can also machine an annular groove on both sides of the oil hole in the bushings of the rockers. This will allow the oil to flow to the...
Call me, I work at JE. 714-898-9763 ext. 280
Hey Bob, I think you may have tried to send me your fuel info, nut my inbox was full. I've cleaned it out. Can you send it again. Thanks
It's very simple. If you have an area chart, you look to see what size nozzle flows approximatley 1/2 gallon. That nozzle will have a certain...
Before I call PSI, has anyone got any experience with PSI's hi helix blower? Is it even available yet? How much cooler is the outlet temp....
We tried everything for years. Then we found a 4 ft. long pipe and lots of grunt. That stopped the galling problem for good. Mike gets the torque...
Might be doing some IHRA stuff next year. I'm familiar with screw blower hats, but not up to speed with roots hats. What's out there? Who do you...
In all the years weve used them, we never had one stick. We always drained our fuel system and used a filter between the pump and barrel valve.
Waterman makes check style nozzle bodies also. These are better than the Enderle's. You don't have to flow a Waterman as they are just about dead...
Dribblers are low pressure port nozzles. They "dribble" fuel at launch rpm to cool off the hotter cylinders.
Fuel pressure has a lot to do with this also. if fuel pressure is too low, then changing jets and nozzles wont have much of an effect. I've seen...
This can be a difficult question to answer. Dribblers will work, but might not be the answer. You need to look at blower placement. What kind of...
First cam is 292@.050 with a .500 lobe. Not sure what the 2S4-195X is for. Usually with Crane the "X" means it's not quite ??? (ie, not quite a...
Southern California area, blown alcohol experience, tuning, engine building, have references. Looking for a paid position with all expenses paid....
