Separate names with a comma.
If it's rear-engine -15, if front engine -20.
No pneumatics, no 2-steps, no timer/rpm shifter, each action must be controlled by driver. Convertor type aftermarket trannies can have...
Yes and no, it was cut down the middle and a spacer/joiner inserted, it fits a 1/2" tall deck, (11.220") not a 1/2' short deck. Had a set of...
If the heads have never been repaired you shouldn't have any problem as long as you're running a fairly conservative tuneup. I ran a similar...
That was the impression I got, too....
Most of their stuff is tractor and truck pull, 1/2" tall deck, would that long of a belt work on a std. or 1/2" short deck?
They can make finer adjustments on overdrive ratio's with the 8mm pulleys since the pulleys have more teeth than the 14's. They usually change...
John, They run with Bobby Marriots altered group down in Texas. You might be able to find a contact at: http://www.outlawfuelaltereds.com/
Most good steel blocks can go .100 over with a sonic check, trouble is once you fill the block, I don't think sonic is reliable. The head bolt...
Ouch!!! Mine usually pops the glass out when I do that............. :D
Lowcountry, How would you compare the glide to the Bruno setup? Do you use one for slick tracks or is performance about the same with either....
It's a JW case with a hodge-podge of internals, big input, 1.64 1st, 10 clutch drum, mostly BTE and PTC parts with PTC 10-inch blower convertor....
You also need to have a blower, squirrel cage, etc. on the convertor itself between rounds. Once the convertor is pressurized, there is not an...
Jim, is that you? Were you in your car or Rocky's? Lost your number, call me.
Yes, they fit the 17" wheel, P/N D-2404.
After re-reading, I realized that I might have been a little confusing. From output shaft to end of pinion was maybe 2-3", it was when the tranny...
Al, to be honest, I'd just be guessing on the measurements, I sold the car almost 3 years ago, but I bought the tranny from Snyder in '02, at that...
I don't have the car anymore so don't have measurements, but I had a 2-speed with the 6.7" bell and shortened output shaft in an ex-fuel chassis,...
Greg, How many times have you boat raced below 60 degrees...........Hard to find good ramp people when its that cold................... :D
WJ, I used a setup like this on an old jet boat that had twin side tanks that were lower than the injector pump (straight port injector)....
