Separate names with a comma.
Where is the best place/price to get gt 8mm belts? 1600 200T Thanks! sean
Anybody have a good source for Hoosiers and 8mm belts? need the 18900 tire. Thanks!! Sean
Does this work off a clutch switch? how does it activate? when it see 12 volts? Anyone have a certain way they wire? appreciate any help Dave...
Who makes the 9" 10" rear end gear? Someone make a billet center secto to if I am not mistaken also. Thanks, Sean
What type works best with the blower set-up? acd? Dedenbear? thanks, Sean
Looking for some help with some wheel speed and what to look for. What type of wheel speed should I be at or at least in the ball park at on my...
Confused here:confused: Ok I am using the blue wire from my clutch switch to activate my 2 step and solonoid for fuel when I press the clutch...
On the 8971 can the rev limit be programmed to be shut off? Guy told me it could be and I did not think so. sean
Is there anywhere else to buy pulleys besides RCD? They never have any stock at all. Thanks! Sean
Is it worth it to change my clutch to a lock-up? I have a aft 6 finger triple disc. And if so how would you go about it? Appreciate it as...
Is it best to place the nozzle sensor off the distribution block for the port nozzles? And for the pump pressure where is a good place for that?...
When figuring your OD I see there are so many pulley combos out there. What is the best way to figure what pulley size to use? I am trying to be...
Which style is the best to run? Thanks, Sean
I have a 4 pole electric fuel log from electromotion. Where is the best place to plumb the fuel inlet? backside of the bv? a return? should I run...
Hopefully I did this right. I put a piston stop in the #1 hole. Rotated the motor till it started to roll by the stop turned the screw in a little...
Where is the best place to buy nozzle jets? Need to buy a good assortment. Thanks, sean
I am trying to dfnd the rubber seal that goes between the blower (screw) to seal the bottom of the blower on the plate it sits on. Appreciate any...
Is there a rule of thumb to use for percentage drops between gears? Right now I am at 33%. Using a 3 speed. Am I right that if it is to close...
What is a good size for a puke tank? 2 qt? 4 qt? Thanks, sean
Has anyone used there product? seems to have a pretty good sample rate and data accessories. Sean
