Separate names with a comma.
Ok this is the old man talking now. I read the above link and failed to see a mention about touching said bolts with your hand. Hydrogen...
In my opinion its BS, if touching a rod bolt made it corrode and break, there would be mayhem in every oil pan at the strip. Sure, I wouldn't...
Is that a hint that you want your car to be the host? I think it might fit.
Ronny We have 1/4 mid plate and front plates, we havent used any engine bracing but we are going to now. The yoke doesnt bottom out, but we are...
why????? The idler is on the slack side of the belt. The belt teeth will always be ingaging the idler teeth a little off then slide on the teeth...
With the problems I've been having I'm not quite sure why you want the damn thing anymore. Never to much motor!!! Man is it a ride.
no teeth I wouldn't run a toothed idler pulley no matter who made it. RCD builds good stuff but with the conditions the idler sees I would think...
Well if someone built a converter that didn't make heat they would be a millionare. I always let the motor idle a while after a run, usually...
rod ageing Aluminum will change its properties after rolling or forming but VERY little after cooling off. To cover all the posibilities caused...
Right now we dont run a cooler, never needed one. Instead we loop the lines with -6 hose, we just rigged up a pressure gauge in my loop and got 90...
I checked that when I put it together last time, it moved easily on the pilot by hand. How much flow should I be looking for in the cooler...
We run a Wedge headed KB-5 block in a 3200 lb door car with a glide. We keep killing thrust bearings, only the rear surface, "crank wants to go...
Our injected sbc does the same thing, never a huge flame but always somthing at idle.
HAHA... MMMM the smell of nitro, I have to keep a few gallons around at all times just so I can motivate myself through the winter.
Well now If we all go to EFI with ECU to watch our EGTs and CHTs so our ECU knows what to do why dont we all just stay home in front of our...
Does running closer to coil bind reduce the effects of spring flutter or surge, just something I have heard about wondering if there was any truth...
Manley make a nice heavy 3/8 and 7/16 pushrod. I think they are .165 wall, I run the 7/16 and love them.
I like the longer rod idea, I would run as long a rod as I could get. And as an extra benafit you can run a shorter compression hight piston. I...
Yes, we use one too, and we always get blue shop rag lint out of the filter, maybe a few tramp balls of silicone, and a few brown hairs from our...
Yes I have, and it was great. I ran 25% with the 14 to 1 injected motor. I havent done it with the blower, sounds like a bad idea to me.
