Separate names with a comma.
The way my kid launches sometimes I think about maybe taping him on the head to see if he is all there
I like that crank bolt idea, never thought of that.
I think you will be plenty happy with the HP you get out of your combo no matter what head you have on it. What kind of power are you trying to...
OK so everyone is on the same page what is the actual correct method. Cold/Hot, crank rpm, throttle plates open or closed [Blower motor]?
I agree if you feel you are short on air spend your money on the top. 30% wont cost much more:)
Corn Husker Method Stand your crank on end on a good solid surface like a heavy bench. Take a small hammer and tap on the crank in differant...
We were using a 20-50 oil not sure what change did the most good but we are going to stick with the Brad Penn 70. We warmed it up with tank heater...
Ok, I want to thank everybody on here for the input on my last few posts. We ran 5 passes at KCIR and the thrust bearing is just fine, no endplay...
The first run was a 8.24! That new converter was worth the money.
We ran 20-50 synthetic before. Our system one has the 70 micron filter in it. We made two very good passes today and have no shiny stuff in the...
We are running a flex plate from Reaction products its alum and suppose to flex real good. Brad from Bradco told us to run 60 lbs at the return...
Ok we went to an M series clevite bearing and gave it .011 clearance on the thrust. We are heading to Kansas City this weekend to see what happens.
I agree, its easier and cheaper to take a peek at a few bearings, or ALL of them than it is to hurt one.
Ok, everyones opinion is on here already so let me put mine in. It doesnt matter what the % change in overdrive 25%-30% = whatever %. Its...
This block is near new, never windowed, just had it line honed before this last bearing just to be sure. The last block we bought at a sale a...
We added 2 ties to the frame to the front of motor with heims. 3/4 moly tube and can see no damage. Maybe we need more this problem compounded...
OK here we go again. 1 pass 1/4 mile rear side of thrust bearing GONE copper compleatly gone. We linked the motor forward so no rearward movement...
I use rubber on all 16 of mine. I think they are easyer to deal with. Im not saying they are any better but I like them.
I just have to say, very nice engine compartment, not a whole lot of clutter, thats not an easy task. I like it.
Could you use the NGK R5671a -10, they are a hell of alot cheaper. I run the -8's but i dont lean on my motor much.
