Separate names with a comma.
Mike, I use this with a screw and do the usual test hits to even everything out and read the plugs. I find that it's usually about a gallon less...
Yes, that should be pretty close at 8000 RPM's.
I've had problems with the Merlin 3's cracking in the deck from the head bolt to the cylinder on a few blown engines. Never had a problem with the...
For a blown alcohol engine a safe tuneup is a BSFC of .0053 GPM per HP. That should get you close for a starting tuneup. .3 gallons per pound of...
Shawn runs the AJ 481X billets stuff now. He had Dart Big Chief's and then Brodix 2005's after the Darts. Never had any valvetrain trouble with...
I've built and run a few Big Chief/Duke engines. I have a customer that runs 1802 Dukes on a 540 with a screw that has been as quick as 3.94 @...
Yes, when we would warm up the car. My crew guy that brings me in to the pre-stage beam hated it also. If it proves to make more power, I'll try...
Enderle has a upright three door unit that works real nice. They also have a billet filter base with a radius entry that can be modified to adapt...
I run from 5.750 to 6, depending on track.
I tried the M5 in my blown engine. The fuel pressure at idle was so high that I had to reset all the poppets. Not sure what they have in it but it...
I had another problem when we tried the M5, so I'm not sure about the power difference. We did run better 60' numbers, but we were at a good...
What Lonnie said, plus it seems to have more fuel flow and pressure at idle. Even after closing the blades some I still couldn't turn the fuel...
The wires on my engine have have about 20 runs on them. Not sure how many they are good for. Ken Walsh changed the cap, rotor, and the wires. I'll...
I know of a few guy's running the 12* Ray Franks/Raptor style heads that seem to make good power. On the wedge engines that I build, I like the...
They have a new HANS that sells for around $730.00 thats about one pound heaver than the carbon version.
You can buy longer bolts from Jesel are T&D. Drill and tap the exhaust threads deeper and use the longer bolts. Do not over torque. This will pull...
I always use a Clevite H series on a low boost engine combo. Try to set them up at .003 to .004 clearance and read them often when you first start...
I used the pioneer mag drive on a New Century block with 18* Big Duke heads. With a MSD 44 you have to notch the valve cover rail and the mag will...
Mine has four inches in the center of the tire and It's cutting the body. Not sure how much of that is tire growth are body squating because of...
Thanks for the info. I tried MSD first but never got pass hold so I thought someone here would know are tried this before. Sure would make wiring...
