Separate names with a comma.
Green loctite is significantly better at holding converter to flexplate bolts. Widely know fact and I've seen it myself. Only thing you have to...
I run a 2.10 rod in a BBC going low 6s at 2100 lbs. I feel like when I switched from 2.2 to 2.1 the upper rod bearing got a little easier to...
A crossfire seems like the only plausible explanation. If it were me, I would probably chalk it up to laying on the chip and something went wrong...
I can't imagine getting my BBC to idle at the egts Mike mentioned above. Mine likes about 800 average. I have it setup so it surges pretty good...
Lean it out till it pops/bangs/smokes, record that number, repair, don't go that low again.
I ordered a roll of high temp silicon from McMaster about 4 years ago. I don't recall my exact thought process, but apparently decided that...
Food for thought: SSI can probably fix any of their blowers if something happens, assuming not catastrophic. Nobody makes a replacement rotor...
I think it was John that I dealt with when they reground one of Marks cams to the specs you listed. He was supposed to just clean up some minor...
I've had great luck with Bullet nitrous cams designed by Mark. They ruined one of them by regrinding to the specs you listed above. It wasn't...
I ran mid 6s with a 4 1/4 gallon tank. I spent some time getting it to idle fairly efficiently. I was using just under 3 gallons most of the...
PM sent with phone number.
I have a bird with shaft and red butterflies. Probably a 9/10, couple scratches. I can text pics in a day or two.
Good call on some things you mentioned. I think I will take a closer look at spark plug depth and maybe repour each chamber, not sure I did that...
The problem predates the line swap. I went through my notes and I've been putting 1 or 2 numbers in this cylinder for awhile now. I also didn't...
4/7 swap. Mfi. Just put all new hoses on a couple races ago (thanks Will!). Must be the intake/blower but I don't see anything obvious. Is...
SSI F3 on a BBC. 1 to 8 are only a few numbers apart except for #3. I'm 6 sizes bigger nozzle than the next biggest and it's still almost a...
I have to use 700+ in spuds calculator to get my numbers to line up.
I started with an old JW that was too aggressive. Marco tried to adjust it a couple times before it started coming apart and he built me a new...
I probably end up draining it between 10-20 runs for one reason or another (converter swap, health check, etc.). But I'll reuse it at least once...
I burnt my hydraulic fluid for the first time ever earlier this year. Ran 3 passes pretty close together before I checked converter temp. It was...
