Separate names with a comma.
has anyone used this process for their frame? how do they compare: Powder coating, Durability, weight, cost Spray paint, Durability,...
mine is on 20
thanks Mike I watched the video on msd pro mag, they use 0-26 or +-13 degrees in the video
what is max timing retard for the small cap before I will run into trouble? thanks
anybody tried one of these high speed cameras to look at rear wheels? there are less than $300
negative side of coil should already be grounded to chassis just make sure the plunger case is making good chassis ground also I ran a wire...
thanks summit price $5.95 Mouser pirce .94 thanks again
can anybody help me with the AMP part number of the 2 pin connector that is used on the Mag 44 trigger cable. it's also on the mag timing...
read another post that says should run 60% in hat and 40% in port is this the case for screw blower also?
we use this one https://computechracing.com/raceair-weather-station-p-2.html?zenid=9337d27d11a4d1d75f55bdbc19fb4fa4 built my on pole and...
we use on board stock starter, 24 volt cranking I use a 24 volt relay wired to the starter so while cranking relay switches to mag trigger and...
msd 8134 or something else What do you use to kill you mag? thinking it would be best to keep coil wires from inside vehicle
thanks Mike we usually change bearings ever winter :D
Blown SBC rod bearings from Clevite is it worth the extra to buy the coated ones? summit prices CLE-CB663HND $8.95 or CLE-CB663HNDK $23.95
we run brodix -12 at 35 degrees
just heard from PSI $150 to polish it $200 Dow 7 it plus shipping to and from both places, it's not done i house after I looked at it...
anyone refinished their PSI mag hat? process? cost?
thanks for the info PSI has told us that we needed to run 8mm as it was better for the blower that is our reason to switch to 8mm
is there a relationship between size of top pulley and belt brakeage? what I am asking should largest possible pully be use or is smallest pulley...
Titanium cracks and droops if you don't keep them tied up our steel set weights 19lbs each side
