Separate names with a comma.
Pneumatics The liquid CO2, how do you go about refilling the bottles? Do you get a large bottle and fill from it, or take the small bottles and...
I am thinking of going to air pods on my Lenco and getting away from the lever shifters. I have seen some info about setting up the pneumatics for...
Fuel Pump/mag Combo Drive X2 what Nathan said. George built me one a few years ago. One of the best quality if not THE best combo drive ever...
Data Logger Systems We ahve been looking at the Performance Trends Datamite USB. It has all the same features as the RPM plus it has an onboard...
What Oil We run Penzoil SAE 60 in our blown big block chevy Works fine, bearings always look good Corey
Burn outs There's nothing better than hitting the throttle and felling the rear of the car snap up, then the smoke starts to blow around your...
Anybody know how I can contact HTC Products(hank the crank) his web site is down and the number I have doesn't seem to work. Thanks for any help
Oil Penzoil SAE 60
Fire Systems I use a Safecraft 20# system in my top sportsman car, real nice system and you get everything from tube to nozzles to tube clamps...
Lenco or Glide I run a similair car to what you are running. Strickly for the fun factor I run a pedal clutch, Lenco with levers. May not be the...
Caster Angle I would say 34 deg in a front end is a bit to much. I put 15 degrees negative caster in the funnycars and dragsters I build and have...
Seal Just use some permatex "The Right Stuff" on the faces. Just a lite film, that stuff is wicked. Once it sets you can almost take the bolts...
You should be able to adjust the slack out of the shifter with the tower. Do you have the jam nuts in place? What are you running? 40 lbs is...
Engine set back If your body is very tight against the injector, ya that would be a problem, but if you were going between 64-66" I guess you...
You could extend the length of the shoulder hoop tube at the first slip tube to accept the different engine positions but you have to weld in the...
You make a very good point about the setback being to much. I'll have to try putting the engine at 65" the next one I build to see if there is any...
Engine location Funnycar I usually put the engine at 63" from the center of the rearend to the engine side of the rear motor plate. Hope this...
Timing Question What kind of boost levels are we talking about? That will have an effect on total timing as well.
