Separate names with a comma.
I'm in the market for a new set of Pushrods. Building a 540 BBC conventional head blown alcohol . Cam lift is .800. I want to keep it around 8000...
I need some opinions on the Indy Blower manifolds. This is a max effort, 14-71 hh retro hh> 540 cid. Are they really better than the regular...
super mag $465.00 for the dual range/w rpm switch. Corey
super mag Now that is a true rev limiter. I'm ordering one right now.
Super mag Thanks Blown 375. I called Autometer and their box just cuts the ignition off as though you stabbed the big red button. I'll pass...
Super Mag Did you say Autometer makes a rev limiter for the Supermag?? I have the PSI limiter but it is just a centifugal type, when it hits the...
Mag Drive Slightly different appliction, (chevy) but I want to put my vote in for the Sitko drive. George built me one a few years ago and its...
Head Gaskets Sorry to Hi-jack this thread but I have a quick question. Is it better to put the receiver in the head or the block. I have always...
Head Gaskets O-rings in the head and receiver grooves in the block. SCE copper gaskets, annealing is ancient history with the new gaskets. I have...
X2 on the spirolocks. Corey
Wet Cylinder Stupid Question but, is that cylinder building the same heat as the rest or any at all?
Hampton I don't usually slam people like this but, I wanted to get in on this... I have a short story about Hampton. When I changed over to...
Lenco Rear Seal If noboby has the seal number before tomorrow I will look tonight when I get home and tell you Tues morning. I get front seals...
Lenco neutral Phone Lenco and tell them you want to install a neutral in your reverser. They can do it for you, or they will send you the parts....
Rods I just had one journal welded and ground to standard. He removed and installed a new thrust flange. Micro polish,crack check, straightness...
Hung the rods x3 on Marine crank. Had mine done last month. Talk to David Eden, amazing workmanship. Corey
Estimate I'm just looking at the power estimates and I'm wondering if the heads you are using have the potential for the 1800HP, mark6052 talked...
Et I agree with Ken. I would go to a 4:30 gear and remove the rear section of the Lenco and make it a 3 SPD (gotta love Lencos). Sounds like a...
Co2 Thanks for the info:D Corey
