Separate names with a comma.
Is it worth putting a windage tray in a blown alcohol engine. I used to run one with my old block but with the new block its going to be a bit of...
Valve to Piston Clearance I'm kinda gonna hijack this thread and I hope this is relevant but, are the numbers that are going to be discussed...
Gear Drive I looked at the Donovan and it looks pretty much the same as the Milodon.The Donavan and the RCD look like they are all billet as...
Milodon No it can always be degee'd in,its just faster with the hub with more holes. Plus you can move the cam in finer increments when the hub...
Milodon Drives I have been using a Milodon drive since 2002 and have never had to replace any parts, I change the bearings and seals just because...
Valve Lash I just notice that this was an exhaust rocker, forget what I said. Guess I should read before I speak. Corey
Lash Problems This is just an observation and I don't know if this would have any effect on your lash problem but, I noticed your seat pressure...
I just got off the phone from my piston builder and he asked me to provide him with my valve "free drop" in order to get my valve pocket depth...
Piston Comp Height Its pretty easy to figure out. All you do is take the block deck height, subtract 1/2 the stroke, minus the rod length. But...
Fire Suit I went with the Stoud suit, it was about $900.00. Just make sure you choose a neutral color. I chose the lite blue from their website,...
Injector Spacer I built one for myself a while back, I haven't really been able to test the performance benifits (yet) but it does give you a bit...
Fire Suit When I got my -15 suit done, I got a order form and went to a local taylor and he measured me. Think it cost me 40 bucks, suit fits...
Piston pins Thanks for the advice. I going with Mikes advice and going with the 1.094 pin and his "fuel" rod. Cheers Corey
I am in the process of getting some pistons and rods made and I need some advice on wrist pin size. This is a 540 chevy blown alky. Should be in...
Clutch Linkage I usually build my own. Just thread heavy wall CM tube and you can get the rod ends at any bearing house.You could also use tube...
Tube Cutting Milwaukee Chop saw. I notch with a proper diameter cartridge roll. takes longer but the fit is perfect. Corey
I'm going to try Diamonds I have been hearing good things Corey
mnifold If everything matches hit it with the "Right Stuff" and it will seal Corey
Head Gasket What bore size are we talking about. That will make a difference.
Lenco How old is the Trans. I just overhauled mine and it had the old style washers in it. The new roller plates use a much thicker washer about...
