Separate names with a comma.
I just went through the wrist pin sizing thing not long ago. After all the smoke cleared, the best pins to use were straight wall and around .250"...
Plug Question Again, the heat range of a plug in an alcohol motor has no effect on the thread heat or the burning of the cadium on the flat...
Clutch TO Bearing I just fabbed a couple of tabs and bolted them to the candle stick mounts, then I drilled the throwout bearing retainer. You...
Oil I always run the SAE 60 with a liter of Lucas for good measure. Bearings always look perfect. Corey
Question You said you were going to change to Titanium valves. I don't know about going faster but the valve change will ensure you continue to...
Cam Help I have never installed a cam advanced for a drag application. I usually install my cams a 4 Deg retarded. Gets you al ittle top end. I...
Altitude I don't plan on comparing info with anyone, so the Kestral unit I have will be the only one I ever use. :) Corey
Kestral Thanks for all the info guys. Corey
Valve Springs I pulled the build sheet for our heads and here is the info. Manley Nextek springs #221448 360Lbs closed @ 2.09" 1070Lbs open @ 1.2...
Suspension tuning The problem with attempting to give you a good starting point for your chassis is, without knowing the weight bias and the...
Kestral Thanks for the info guys. I did a little more reading and they said in the manual that you can get altitudes from google earth. I tried...
I just got my new Kestral weather station and I have a question. When calibrating the unit do you use the standard 29.92 in/hg barometric and then...
Head Recommendation There's also the basic Dart 360 solid head. If you don't spring for a head company to do the killer cnc work on them they are...
Cast Crank I'm going to put my opinion in here if a may. I believe the reason people say "don't do the cast crank race engine thing" is because...
Blower When I bought my first blower 14-71 HH Retro from Mert he said he wasn't going to sell it to me unless I ran it at 27% or more because I...
I'm new to the high speed as well, I am going to install one for the season. My question is, putting it between the shutoff and the barrel valve...
Throttle Blades Are the blades frosting up and sticking to the injector opening. I have this problem once and a while. They frost and it takes a...
New Combo You can get blocks with almost any deck height. If you need to stay with a cast iron I think you can only go as high as 10.2. With...
BBC Combo I am building a 540 4.5 Bore tall beck (10.2) Big M, 4.25 stroke. 6.700 GRP rods. This seems to be a pretty standard combo from what I...
Big M I have the same block and I was going to go with the 565 CID, but I didn't like how little material was left between the bores. I decided...
