Separate names with a comma.
olds The timing depends on the chamber size.14 degree stuff will make big power at 30 degrees.32 max.I don't know clutches but it will be mean on...
bbc We had less stuff than you and went 7.60@3100lbs with 526 inches and a glide. 7.80 with a 468. I like the 540 myself. Super strong crank with...
bbc Put more oil in it. The hoses from the heads help too. The heads are full of oil after the burnout. I can't believe it hasn't blown up...
ports Another thing to keep in mind, there are other thin spots you don't know about esp if they are cnc'ed. Sleeve it and be done. There's...
plate I've seen blowers with large inlets and outlets and all kinds of plates bolted on to make them smaller like a modern blower case. Keep in...
dyno There's a nice big capacity dyno in Wichita Ks. You need to have your own tuneup plan. Tracy Pedigo owns it.
sleeves If you setup BBC heads for 1/2 inch studs you'll have sleeves and holes everywhere if the ports are big. I've never had trouble on the...
shift You have a LOT more power available. crank at least 30 degrees of timing in it. 32 max for big chiefs. You will have to retard on the...
retro The retro setup will have the opening cut into the front bearing plate. The retro design doesn't gain nearly the power of the high helix...
We finally got a flowmeter installed. What do we do with the data? We have a good running roots auto promod. Thanks, Mike
blower A high helix will make hundreds more horsepower than std rotors in the same case at the same od and boost. A Kobelco or other trick blower...
idle I set the BV 69% and adjust the blades running to 2200-2500. 14-71 superman with a quadstar hat. Keeps the oil clean too.
wetsump on our wetsump KB olds we drilled and tapped the rear of the heads in the valve cover rail area and ran 3/4 hoses to the pan. We metered...
shake You didn't say what tire you run but your gearing is good for 33.5to 34.5 tires. You have the timing control so you don't need to soften it...
idle I found just raising the idle fixes it. We run a real lean barrel valve with a convertor. We always check the idle with it in gear when...
dry sump I never have understood the hemi style drysumps that carry 20qts and barely scavenge anything. With weak scavenging its not a drysump....
shake Tireshake is the whole deal with a convertor car. The window between going fast and shaking can be small. 2 degrees on the hit can...
starting we always started on gas until a few weeks ago we ran out and used alky with no problems. Promag 44 with 24volts. I wouldn't be...
rods We used venolias and had good results but switched to brooks eventually because they were super quick on turnaround through Oddy's. We have...
Finally got a fuel flowmeter. I noticed the ADRL screw cars are about 50/50 on the flowmeter installed after or before any highspeeds.I don't...
