Separate names with a comma.
studs you can also counterbore or grind a little clearance on the bottom of the stands. Big Chiefs hit all over the place.
ti Ti workhardens easily so it weakens the valve when straightened. They are really tough so they can take some abuse but I don't think a 100.00...
The line loc just keeps the car from rolling on the sprags. It's in bruno's instructions but I thought it was a lame bandaid so I fought it...
trans They are both fast. The bruno is probably a little tougher but heavier and bigger. Coan and Chance have most of the records. Chance stuff...
rods Venolia makes them. They bought the tooling. 1000.00 set for a hemi.
We have been thinking about switching but heard there are still issues with flakey pressure downtrack. Supposedly some have the problem and some...
bbc my current setup is reliable it's just not fast enough and i'm trying to make gains without getting back into big chief valvetrain hell. I've...
We ran a big chief chevy with a good roots blower and made around 2400hp at 9000rpm and 46 psi. We knew it was getting to the limits of the combo...
bearings Does anybody stock V series bearings narrowed and chamfered with the coating?
springs I'm in the same boat I think. I run Manley nextek and if I set the coil bind height per spec they are over 500lbs on the seat because I...
ratio the cheaper/easier way to test your theory is to throw a 4.30 or 4.56 in the back. You need to turn 9000 through the lights. At 4.55...
ratio 6.50 ratio is average for a promod with 34.5 tire. If you are making good wheelspeed and pulling out some timing I wouldn't go with a lower...
427 I don't think the ports are off by an inch. Do a search, it's been discussed before. Sounds like you have some good parts and experience with...
bbc Oddy tried it a few years ago and claimed some gains on the dyno but nothing on the track. Extra weight and expense plus if you wound the...
bbc get a decent 1471 high helix and detail the valvetrain and it should make 2000hp easily.It won't need much more than 30 psi and 8000rpm to...
pump we always had excellent luck with enderle pumps with our roots. We used some additive in the alky and never wore one out. Almost all you see...
belts Mike, we never had a belt failure on the starting line but it would fail a few hundred feet out usually after the shift like most cars. A...
dots Riding the dots is difficult in a car because it breaks the blower belt when you hit them hard. Any rev limiting is hard on the belts....
port Most BBC port data is for normally aspirated applications. A huge good flowing port on a small engine will be lazy on the bottom but might...
And what does Mallory have that moves timing like a six shooter? They don't even have a decent rev limiter. put a promag 12 in it and you'll...
