Separate names with a comma.
Stepping up the overdrive for a moment, I'd like to pose the same question with respect to Top Alcohol type use. Now that both superchargers...
In terms of the Ti content, just the hat/donut, or the flywheel too? Is there much of a difference between a Crower or an AFT, in a TAFC deal?...
Just curious. What is a Bacman head? What stud pattern? Thanks.
I wonder if someone could point me in the right direction. What data logger systems are currently most prevalent in alky funny car and nitro...
Thanks. A guy around here was trying to tell me that some of the roots guys were up around 13:1. I just found that hard to believe.
Just wanted to check something. What are typical compression ratios for competetive TAFC/TAD motors? Heard some numbers bantered about lately...
If they said it would work "great", then take take their word & try it out. If it does not work then you know where to send it back to. Waste...
It all depends upon what application you want to use this in...... XDI looks to be a fairly accurate waste fire DIS ignition system, based upon...
Anyone running Pauter rods, either all AL or AL with steel caps? Comments good or bad?
When people say H3, I am assuming that they really mean R3? There is one big difference between the Hans and the R3 that may or may not be...
What about welding/brazing the decks and filling them with water or water wetter?....
Well, the time has come to shell out some $$ and buy a clutch surfacer (all clutch surfaces, friction & steel). The question now is "what" to...
Thanks.....
Mike, if I read correct, you are launching at WOT with the 2-step in effect and not dumping fuel? Do you see any issues re: plug fouling or EGT's...
It was the k9's. General advise seems to be to stay away from a K9 rotor, no matter who's case.........
Talk to the folks at TFX International, in Toronto. They'll bring the whole deal right to your house, or to their depot. Which side of Toronto...
I would not recommend the Hawley/Swearingen course, if it is tuning info you are after. It is a pretty basic mechanical course. I took it a few...
Thanks Mike. The billet rod deal confuses me, although as you say there are people having good luck with it. In the case of a forged rod, would...
Two dumb questions if I may...... What is an L19 bolt? For a high RPM application, is it best to use a forged AL rod versus a billet rod?
