Separate names with a comma.
Hey bobby, thanks for the feedback. Just out of curiosity, what is your % fuel split in terms of fuel above the blower versus fuel in the ports?...
Why not just put a bung in the side of your 4 gallon, and let the excess fuel above a certain level flow back to the rear cell via gravity? Or,...
Anybody ?......
Has anyone had good/bad experience modifying the PSI C or D base plate openings for better performance? If fueling is mainly 'ports' then is the...
Such nitrogen rings (Wills rings) are pretty common fare in high end engines. Pay careful attention to the maching tolerances and surface...
A picture of the deck face and head face would probably spark some ideas. What locates the tops of the liners, and how much meat is around the...
Hey buckeyehauler, check you PM's....
That does help a bunch. Thanks!.......
We have a couple of older (cast) Arias 8.3 long blocks with the above mentioned 3" mains. We would like to ressurect these in a blown alky drag...
Accusump(s)? Does anyone make a larger than 3 quart Accusump type deal? Flip side of this question, has anyone found it necessary to run twin...
Thanks Bob. Did the roadster pick up ET or MPH after the switch to the Lencodrive? Back when the roadster ran the 4-speed, was the clutch setup...
So, what is the general consensus? If allowed, would a 4 speed be faster/better?..... Outlaw could run a 4 speed.
eli, please check your PM's......
What are most of the alcohol guys running? A 20 or a 44 Mag? I've been told that a fresh 20 is more than adequate for any alcohol racing, and...
We are attempting to make an educated guess as to whether wide band exhaust gas oxygen sensors (WBEGO's for short) could possibly be applied to...
Have an old motor that we've pulled out of storage, to be run in a PSI charged outlaw door car, on alcohol this year (with higher compression)....
Out of curiosity, and for setting visibility while in the shop, what is the standard for the positioning of the tree? Distance forward to the...
Yes, especially curious whether it can draw/maintain a decent measure of vacuum in a blown alky application. On a related note, has anyone...
That was helpful. Thanks..... I know that in TAFC, the rules dictate 3 forward gears. Imagine for a moment that there were no such rules,...
I have a couple of quick TAFC questions that I was hoping someone could help me with. In a modern Roots blown TAFC deal, what is typical for:...
