Separate names with a comma.
Do you think that would help or hurt the tendancy to tire shake, especially if one rear tire went to shake before the other?........ Thanks.
I'm slightly curious about this statement. Would like to learn more. Thanks......
Agree totally. The same could also be done for a regular tear down reliable drag engine, "but", the initial machining would have to be spot-on...
Not an uncommon practice in extreme $$$ motorsport engines. About $35 bucks per hole in bulk, if you figure out how/where to buy direct. The...
It all depends upon "which" 36 GY tire you have. They vary. If you contact GY racing, they will give you a graph showing free radius versus MPH...
Agreed. What would be the best way to measure %O2 ?........
Quick question. What are most of the screw blown big RPM teams running for piston pins? 1.094 or 1.156? Preferred source? Thanks.
I was thinking about burst panels awhile back (have a dual on the PSI and a single on the manifold in our case) and had a couple of weird ideas....
What about a spring loaded pop-off plate that would relieve pressure and then reseal, or would that not relieve fast enough?
Should be fine lapping Ti. The only possible downside is if your Ti valve was originally coated in any fashion, then you could potentially wear...
I tend to think it all boils down to the "dynamic compression ratio" inside the cylinder, which is a function of the static (geometric)...
If I'm not mistaken, I think the blower size/name says it all. 8 times 71 equals 568 cubic inches. That is only the theoretical displacement, at...
Thanks Sean. When you log fuel pressure between the injector(s) and the regulator(s) do you notice any fuel pressure droops or fluctuations...
Mine picked up some surface crud while in storage. What I plan to do is powder coat it in the very near future (body gloss black - lip simulated...
Sean, I'm curious about one aspect of your setup. Do you feed fuel to your injectors from back pressure controlled recirculating loops, or with...
Yes, Harold runs EFI/N20. Good luck with your decision Andrew....
Maybe the guy doesn't believe the the world is "flat" according to those who supposedly know?........
If that weight is with driver & fluids, then my guess would be 1700'ish Hp???, but you'd want to run your combo through a simulator to know for...
As for 1) Yes. As for 2) There are other ways. Have you got a pic of the manifold? As for 3) Yes. How much power are you looking to make?
Very interesting post! Supercharged meth, rich A/F ratios for cooling, high compression, high boost are bad enough by themselves, then to...
