Separate names with a comma.
Thanks Justin. All good points. In my case the driveline is dead square. I have presently a raw .500" rear motor plate which I am going to...
Yes I certainly would like to review those lockup levers. You can send pics or info to my e-mail if you care to. Does their lockup system use a...
Thanks Justin. I hear you loud & clear on new versus proven. A risk to be asessed for sure. You mentioned the top 5 ADRL guys using East/West...
Some photos would be great. Found the Leanders website. You're right, not a lot of info there. Looks like a 7-stand unit. If the floaters are...
Sounds interesting. Will check it out. Does Leanders have a website? Can the floaters be sourced from within North America?.....
Fairly low runs per year, as in maybe 40-50. 2700 pound screw blown P/M with 3-speed Lenco, 4.56 gear, either 34.5 or 36 tire. Will see well...
My own servo design in conjunction with my left foot.......
That would be okay. The more information the better........
I'm curious about a couple of things relating to the clutches used in current screw blown FC's, as the RPM's and loads with those are probably...
Now its clear. See this link from the Total Flow site...........
Are these hoops solid wire or hollow wire? Round in cross section or square? Never heard of these before........
Donovan D500 BBC....
I'm looking at putting a blown meth deal together for a T/S bracket application, using an old Donovan D500 aluminum block that we already have....
Thanks TAD311.......... TOL.
Here's a low buck approach........ Go talk to your local police authority. They will have a traffic investigation unit no doubt, or ask them...
Has anyone tried the new Bohr hat (www.BohrRacing.com) against the PSI Deepthroat with aerofoil kit & lips? Just curious how the two options...
Just curious if anyone has any experience/thoughts one way or the other about the portable Boninfante VF-750 clutch resurface machine versus the...
Agreed, fill slow and listen for the dribble/splash on the floor. Makes a mess of the garage floor though with C23......
Along the same line of thinking, make a homemade level indicator sort of like what you would see on a coffee perc. Fitting near the lower portion...
Was looking at some really nice Venolia nitro piston blanks awhile back, and was kind of impressed by the design. Stout, ready for a 1.156 pin,...
