Separate names with a comma.
Your original question Personally I've never seen a reason to change the ignition timing for different altitudes, have any of you?
Isn't the lead difference between the Mallory and the MSD about 5-6 degrees?
Please explain why a big plenum should show a drop off in boost at high RPM's. One down side I see to a large plenum is throttle response.
I think a 4 barrel intake manifold concept is a good idea and Mike Sage (SCS) did this a long time ago (longer than 15 yrs ago). Unfortunately not...
I assume the setback is better because cfm are sacrificed when forcing the air to turn.
We have SM IV and ours retards about 15 degrees at idle. I've posted about this before asking for possible ideas to solve it or if anyone else's...
If by spud shaft you mean the gear attached to the cam gear (it lays horizontal) than no, its not a gear you can buy from the local parts store....
Are you guys talking blocks that actually came out of cars/pickups? Are these short deck? Or are they GMPP blocks. We couldn't keep truck...
Where does one find a gage like what you are talking about? Is there a gage out there that can be put right on the head that can handle the...
Looks like Isky's cutter only goes upto 4.375 bore, are there bigger ones?
Certainly people are trying and doing many things. But my opinion is that an o-ring is still the most common. I'm kind of stuck now because of...
You should probably call BDS and ask if you can run it on the street with carbs. I'm betting they will say no, because its too tight and so it...
As far as an offset mag drive, you could put a front drive on it, many people sell them including Archers for around $400 new. As far as...
I have noticed several things in regards to this; 1-some valvecovers clear better than others 2-some people bend there injector bodies aways...
How many of you are running harmonic dampners on your blown alky motors? Was it Lunati that used to put harmonic dampning material in the...
I could not tell the difference in tune up, but I have one in the port line and one in the hat line. When running about 1600 HP worth of fuel and...
We put them in about half way through the season last yr and like them. They don't require new plumbing or more hose ends, but they are worth a...
I always use what the mfg recommends for end gap. I have a motor apart right now that has 2 runs on it since brand new, I'll could check it but...
I think it moves the outlets too far back, so basically you end up with the same problem just on the other end of the motor:mad:
Maybe you would like some of the circle track racers "swinging" oil pickups?
