Separate names with a comma.
What are you going to compete in? How big of blower? How fast of RPMs and will you want to run it on kill?
we had enough of them crack right by the flare
What is your experience of plug readings after the motor has been on the rev limiter? Does it make it read richer, leaner or the same?
I do not recall ever having a problem like this. Even when we ran SM II's, than we went to III's and now IV's. We've always used straight alky....
I was hoping you could explain this some more. My chevy buttons slide into the wrist pin holes and are relieved for the oil ring. Are you saying...
what about... Anyone used this shop? http://www.stevebruceracecars.com/
What is this currently used on?
We took a very large fine thread bolt (don't remember the size) and with the lathe extended the threads upto the bolt head. We took a nut and...
In your opinion, is there something dangerous about them? Or what was the reason that SFI got involved?
What was wrong with the operation of the old burst panels that had springs holding them shut? Was it that you didn't know if they popped open?
Seems Arias pushes high tension oil rings so we have used them the last several sets. Before that we didn't and I haven't notice any difference...
I like ours. I've seen too many pancake style filters give problems.
I like your wasp story:eek: Last Aug. we had some hat nozzles plug and torched #2 also, sounds extremely similiar to what yours did. Sand roll...
Do those have inside head bolts? Did it torch the head where the combustion chamber meets the flat quench area? You richened it .010 and it...
How is this typically used? http://www.racingjunk.com/category/21/Funny_Car/post/1927998/Don-Jackson-BDK-s-FOR-SALE-.html
See my post above, I don't know the grit or type.
If no one replies with the dimensions you could index a crank or flywheel in the mill.
We do, they look fine, but have many tractor pulling runs on them.
Jason Amazingly I have torched pistons without hurting the bearing either. It seems to be a BBC thing. I have been in the position where...
How fast were you turning the motors when they exploded?
