Separate names with a comma.
running a bbc with 12-71 at 20% OD..got a set of polished burn-down breathers w/screw in hose an fittings..set up to use -10 an hose;;running each...
MY main bearing clearance ar .0032 to .0034 rod bearings;;..0033 to .0036
What would be pro/cons on using this oil in my bbc blown alky engine?i can buy it local is why i'm thinking of it..half race and half show...
just got my crank support back from machine shop..the crank hub bolt is a 1/2"x6 1/2" long fine thread..what should it be torq to? also idle...
sorry about that..miss spelled it is jegs below is link to it http://www.jegs.com/i/JEGS/555/23604/10002/-1 i no longer need one..gregM784...
THANKS FOR THE TIP;;TO OLD FOR EXCITEMENT[LOL]i found that zigs shows a billet one for $19.95.i e-mail there tech and they said i can use the...
i have clearance and easy access to the block mounted filter just didtn't know if there was a reason for everyone running remount mounts over the...
is there any benifits of running a remote oil filter over running oil filter on block..this is for a bbc wet sump engine don badtoyzz racing...
same here with my bau hat.my front left hit nozzle line so just put a very slight bend in it..can't even notice it now.i did all 4 just so they...
i have a new autometer pro-control #5306 w/reset i was going to use as rev limiter for my blown alcohol engine with a mallory supermag111;;;i keep...
so will my way i'm wanting to do work then?i have the mallory super mag111
ok;;i've been on here looking at all fourms on grounding..here is how i want to do mine and need to know if it will work this way ok.. [1] 4ga...
Ricky ruiz gave me some egt bungs for my headers..i can't afford the racepak data recorder so going have to find something cheaper; [1]the bungs...
ok;;i mounted my coil on motor front plate directly under my mag..now on here was mention about ground wires.. [1]can i run say a 10ga or 8...
pg trans with turbo shaft..can't buy one right now still got to get money together to get my fuel system flowed but it starting to watm up here so...
building a 540bbc blown alcohol engine 11.8 static comp. 731/726 lift roller //114 lobe center //running dur 322--326//dur at .050 284--288...
RICHARD;;thank you for the e-mail..after reading it 2 times it sink into my thick hard head to try differant idler pulley bracket and as always...
have a 540bbc.tall deck..center of top blower pulley to center of bottom crank pulley is 21.5";;27t top and 32t bottom 13.9m pulleys ..best i...
i had a 5" snout on my blower and found i needed a 4" instead..made a trade.my 5" for another racers 4".he recived my 5" first and said that the...
looks like spud is the one then..where is he located?how much should i expect a full flow will cost me?i understand a lot depends on what parts he...
