Separate names with a comma.
Schubeck used to make a lifter exactly like that. It had a cylindrical solid roller element that rolled in a cavity in the bottom of the lifter...
When you say "stuck" do you mean the lifter body, or the roller wheel, or ?......
Out of curiosity, what is a GS ?....
http://powermist.com/
Work backwards........ What is the thread size you need, and do you need flat or taper seal? After that, what hex size? Can you cut down...
I have bought exactly what you are looking for from www.wizardswarehouse.com in the past. I have some new unused extra's here if you want them....
What did the cam manufacturer recommend? To set as per IVO or to set as per C/L? If you have an assymetric intake lobe design it is tricky...
Or you could custom make a ring with a larger diameter.
WOW..... That must take a pretty large tank volume ! In the third link below, fast forward to just past the 3 minute marker. A good candidate...
Check your PM's....
There's space now....
Check your PM messages (Notifications @ top right). Thanks
Like lucky2WD said, the Arias 10 and Arias 8.3 bolt patterns are the same. As far as I know, no other compatibility. What are you wondering or...
How much boost can a person build before actually rupturing the SFI boost disk, aka the Waterman burst panel deal? Have got a manifold with a...
Good point. Also, check that your duty cycle is not overly high and that your fuel pressure differential is not too large. Mike can give you the...
In ND awhile back there was a device being marketed which would allow a person to datalog their actual live timing at the plug, net of all...
When you say "prior combo", do you mean that you have run this exact set of ignition hardware and ECU hardware prior, and all worked fine, or is...
What are you running for ignition hardware, ECU control, and crank trigger setup?
How is the bore distortion under high boost with a 4.467-4.500 bore and a 4.840'ish bore center motor?.........
So could a person use an air assisted sprag deal on the track?.......
