Separate names with a comma.
Trans broke under load..... even at only 9400 rpms, she is hurt.
X2 what GTperf said.
Two things..... first this type of performance is made alot simpler with the help of my tuning consultant Mike Kopchick at RAGE FUEL SYSTEMS. His...
Thanks to Cameron Bradham at Torque Convertor Services for building my powerglide transmission that allowed me to set the record at 3.714 sec in...
Casey, pull your pan and fill it one quart at a time with oil or mineral spirits untill the oil is at your windage tray. Then add more until you...
You are using a remote mount ford solenoid...right? Just jump the wire across the starter solenoid to the batt. wire post. Been using a 12 volt...
beadlocks did not have a TF center..15.1 (I think)...the liner wheels are TAD spec.I guess 15.3 centers would weigh more.. but I don't know how...
weld beadlock with MT tire.....67.4lbs. weld liner wheel with inner liner and hoosier tire...75.4lbs. Both weighed on a really good set of postal...
I had the same problem with a set of beadlocks hitting my Mark Williams brake calipers, I took the wheel...less tires...to my machine shop guy and...
Beadlock is a good bit lighter. Weld vs. Weld.
I agree with NITRO....the MBR Miner Hemi is the shit. I did alot of soul searching and could have bought any engine combo. I went with the MBR...
All you need is TCI MAX Shift Racing fluid, you can get it by the quart or gallon. Used to be green now its red like all the other brands. It is...
I use TCI trans fluid...get it from jegs or summit.
Mike I only do it static to get me close, I fire it up and check both mag and trigger with the car running. I like to see the rotor lined up with...
congrats, good luck.
You have to push back and take the slack out of a mag as you phase it with a crank trigger.... or without. Make sure you hub TDC mark is...
Just recieved word that Don had a heart attack and didn't survive it. It was sudden and unexpected...our prayers for his family, from Jody Stroud,...
How many runs....and whose rods? What RPM did you turn them to?
You don,t need liners at the et's you'll be running. Screws or beadlocks will be fine.
That is Rocky's old car....runs well. Just stay with 4.11 (save some money) and take some pully out of it.....run appox.20% od, and shift it at...
