Separate names with a comma.
Plug heat Thanks for the info Mike Corey
I am going to order a bunch of spark plugs right away, but to get a good deal I have to order in bulk. This is a bb chevy 14-71 HHR will be...
Lenco See Jim now the secrets out ,;):) If you can build and engine (which is much harder) you can tear into a Lenco trans. Corey
Lenco Good point, the stuff I said was for a CS1. Corey
Lenco If you remove the tower completely fron the section does the shift fork feel loose or do the roller plate still hold it in place? If...
Gear drive I use a Milodon gear drive on my bb chev engine and I agree they are a bit of a pain to get the cam timing correct. I had George...
4-link setup Sorry, I guess I should have said "moving the bars" not "dropping the top bars". I meant it as more of a general term not a specific...
Tire shake I can make my car shake so bad just by dropping the top bars, did it once just to see what would happen and I did it before the rear...
Bolt Torque If they are the L-19's with a 1/2" 12 point head the spec is 90 Ft lbs or .006 -.0065 stretch. Corey
Start Up We usually give it a squirt of gas and turn the motor over with the mag off, this gets the gas into the cylinders. Then we turn the...
Chassis Shop Last time I was at the RockyMountain Nationals here in Edmonton the promod field was pretty much split down the middle with Jerry...
Piston to head I usually shoot for .080" total Corey
I guess I'm in the other 5% I use a CM filters (Canton) Billet spin on filter. I love it works great. It's a Chevy deal though. Rebuilds in about...
Oil rings x3 on standard tension. Just bought a set of Ackerly's and Ray set me up with just a low cost regular tension oil control ring. As far...
Mallory Mags If you surf Spuds website (FEI) he talkes about the Mallory mag and the different types of rotors available, but it seems the issue...
Proform makes an 18" Billet wheel with the pie cuts. Basically its a big cross with a degree ring on it. I have one of the Moroso big blue...
X2 on Good Vibrations I get all my King Bearing from them. I have used King Bearings for a long time with no problems. (besides one's I caused...
Crank Repair Actually, now that we are talking about Marine Crank I looked up my invoice and it says they Ion Plasma Nitrided the journals. What...
Crank Repairs From the time I shipped it and back to my door it was 3 weeks. I am from Canada so I think the extra time was it sitting in customs...
Crank Repairs X2 on Marine Crank. They welded and chromed my billet crank last year. Did an awesome job. Just make sure you tell them exactly...
