Separate names with a comma.
I can't remember the name of the what they test the coils with. The fuel teams, aside from bench testing, will use a one-off multimeter with a...
with a whipple at that much overdrive you probably don't need to bleed fuel on the two step. If you do divide boost by flow on the two step you...
Could be a combination of rings and cylinder walls. You have ran your deal long enough you would notice if it was that far off on the bv. If...
I also have an old style black coil (2 terminal) will sell for $75
I have 8 coils back in stock. Tested good. $200 for 2 or $125 for one Will Hanna will.hanna@insidetopalcohol.com 979.415.4959 (no calls or...
I have no scientific data, but I think 100 lbs is worth roughly .05 in the 1/8. Maybe more once the tune up is optimized for the lighter weight,...
Call Ken at Motorsports Unlimited 216-390-4561 he has what you are looking for.
We do roll and punch in high gear with the Kruse Missile TD. We use a throttle stop because Dee has raced for so many years with carb/gas motors...
Back when I drove the Clack TAFC with a Lencodrive, the car owner and I both preferred to roll through the box, stop, get on the tbrake and go up...
There's a number of factors at play with what you mentioned. Beadlock or liner? Air pressure? 2500 rpm on a two step is way, way low for a...
Typically what you will see is it be pretty low early in the run and start making pan pressure probably 900-1000'. With a 'conventional' ring...
Bob Meyer is selling a bad ass Billet 3rd member, give them a call at 619-440-7701
92 over pulley set up with belt. All new, never bolted up or ran! RCD 11 mm 25 tooth top pulley ($215 new) RCD 11 mm 48 tooth center flange...
I had a customer's car that wanted to do the same thing, surged no matter what I did with the BV, air, opening, bleeds, etc. They had a very...
Inventory clearance pricing: Straight to straight line: $20 (per line) Straight to 90 line: $45 (per line) Use at least 6 lines from our inventory...
Give Mr. Carter a call. I think he is pretty definitively "the man" when it comes to blown Ford stuff. http://www.candcmotorsports.com/
I'm sure one would work. I would think the short stud would but you would need to measure it to be sure
Really nice condition .500 short deck BAE Block. No windows, only repair is saddle on rear main. All repairs done at BAE. New top row H-11...
MBR 477 CID Intake to pan Engine from the late Ed Schmeeckle's TAD the last time he raced.. Block F-30. Has Barnes oil pump and the RCD billet...
Just got word that he passed this morning. RIP and Godspeed
