Separate names with a comma.
I ended up gutting the whole inside of the trailer and had it sandblasted and painted,new lino,bench,all new 12 and 110 volt wiring,ect,ect. My...
Do you use the same torque specs with the peanut butter?
Any one ran Midyette Brothers(Ronnie Midyette) hemi cylinder heads. Have anymore info on them?
It was already in effect last season. Advandced ET required a 20lb system for any front motor/blown alky/open cockpit car. I had just bought a new...
Are they still making the Merlin Pro? Its not on their website? Also what are the Donovan D500 blocks like?
New Century Block If I had the extra cash I would go with the New Century but I would need to buy a new oil pan and gear drive. Also if your...
I don't remeber off the top of my head. I will dig up the info tonight. I'm going to switch to a 4.250 stroke when I need to cycle my parts out.
What is a better cast iron block for my combo? I have ran a 10.2 marine block for the last two seasons but I'm at its limits(1600hp). The main...
I'm still thinking of changing to a 4.10 rear gear to get it the ratio(7.74 to 7.38) down a bit. The M/T's need to be replaced now so I thought I...
I'm going to order a new set of Goodyears for my altered to replace M/T's. I've tried everything to make them them work but with no luck. I've...
RG Do you have any pictures of the side door latch setup? Mine needs to be repaired and I would like to set it up as original
I just picked the trailer up yesterday and came home with it 600 miles and I couldn't believe how good it towed even @ 70-80mph. It was empty but...
I just bought an 1978 36' Chaparral and was just wondering some info on them. Where they all the same width? All had the corragated upper panel?...
I already wear a -20 suit but I guess the rules are different for Top Dragster
I'm just looking to build a cover to go over my transmission and thought I would see if anyone else has built one yet. As per NHRA Top Dragster...
Thinking of changing rear gears? Make much difference? 125" altered,2160lbs with driver,Blown BBC,14-71,1600hp@ 7700rpm,Coan XST glide 1.80...
I just bought a Automan and need to trim it up a bit for my setup. What do you think the best RPM to set it up at running on the stands? I usually...
Jason I would bet those were solid 360's? What did you run for a block?
www.safejacks.com Anyone have a set? Any other good brands out there beside Pro Jack?
I checked into the ATI Superglide III before I ordered the Coan XST. Its $7500 for the trans/converter up front and $650/year for 5 years($3250)to...
