Separate names with a comma.
trans 3 spd for quarter mile. The lencodrive is the lightest,most compact and most expensive. I run a BRT with good results and they are pretty...
noble I've heard the track is really bad...we run on a lot of bad tracks but the start is ok so at least you can get the chassis in the ballpark....
ratio Does it shake at all and then smoke, or just completely blow the tire off? I don't know about dragsters but those ratios would work ok in...
combo tell more about the car...are you testing at Noble? Thats why it spun...lol Shake at the shift is pretty common with a glide if the car is...
sump I use the moroso std with no popoff. I doubt it will hold 2000psi but it's been trouble free.
brt we lost several rounds because of the car rolling. It MUST have a linelock. It looked like the brake was creeping but everything looked new...
cooler We're running a bruno, but it should be the same setup for any auto other than the connections. Several people build them for 500.00 or...
tuneup Mike C I understand the low gear leanout. My car is rich on the bottom and getting lean up top. When I fatten the main it will be worse....
tuneup I don't pull any fuel out on the two step. I dump 10 degrees of timing on the transbrake so the egts are only a reference but they do...
Anybody found a good/cheap pump for building a transmission cooler setup for between rounds?I'd prefer 110volt. We've been racing in 110 degree...
Im running an auto convertor car with soft timing downtrack but hitting it pretty hard on the start due to a poor track. It started showing some...
price 8-12K if it has the big input shaft
brooks years ago we ran venolia but switched to Brooks because the service was better. We tried to get the V2 and amazingly the service sucked....
hoosier Be prepared to compromise. I don't think Hoosier has a 33-16 designed for the kind of weight and power you have. They make awesome...
cs CS2 is more common,compact and expensive. I thought there was a weight savings but they seem about the same.Make sure you have the billet...
gorr block I have the Gorr 20 port block with hoses for a hemi...also nozzles and almost everything else for a screw plumbing setup. .50 cents on...
wichita We'll be there Josh. Could use cars for sure. We tested there last weekend and the track was maybe a little better than normal.
Duane I remembered what you said about #2 spraying fuel all the time. It sounds like it's the nature of the psi plate. Obviously,your car is...
cam It's dangerously easy to have our cam move a tooth with a KB geardrive when the fuel pump extension is removed. Make some reference marks or...
screwed I figured this would bring a lot of opinions. My ports are open just above idle. It's setup to run with the blades mostly closed at...
