Separate names with a comma.
im constantly fighting #2 and 7 on my chevy. Make sure it's hot when you stage and dump a BUNCH of fuel on the 2 step.
shake here's maybe useless doorcar advice...it won't weak shake. Wherever it's shaking pull out timing. You're .5 wheelspeed is not crazy. You...
We had all kinds of problems with our 12volt battery this weekend. It's a little motorcycle battery that just runs electronics. It weighs around...
bbc the C will be a lot easier on the engine at the same boost level. Keep it rich and conservative on timing. It will go pretty fast before it...
lifter probably something is pissed off in the combo. Big ignition timing lead will load the exhaust side harder. We had an Oddy cam that...
Several guys were asking me about a baseline tuneup. This went 4.0@183@2650lbs and has been safe. 540 14 degree chevy with indy manifold and...
8973 thanks Mike. RJ has the digiset and the air switch.
Trying to blip the timing at the shift. We installed an airswitch on the lenco pod powering the step 2 wire. When it shifts it holds the timing...
lifter Isky .904 EZ roll. 450lbs seat pressure.
wires Blue Moroso ultra wires live way better than MSD on our chevy. They will custom make them. The service is very impressive. Approx 20 laps...
That would've been good info to have before I killed 2 dist. gears in 20 runs. I'm intalling a new cam this weekend. Mike Dunn assures me that the...
chevy I run the same combo. I'll get you the nozzles sizes within a few days. They are still a work in progress after 20 laps.
n20 I control fuel mgt. with a dedenbear n20 controller/timer. I think it would work ok on a 6 shooter. I would strongly recommend trashing...
what do you guys use for a pneumatic switch to tell the computer when the lenco shifts? I see RJ racecars has one for 44.00. Thanks
timing i'm a little confused on your procedure but it doesnt really matter. If you think there is an interference issue disconnect the 8973 and...
I welded the -3 fitting shut and drilled it. We had a LOT of topend oiling issues back then so I didn't dare pull oil from the lifter galley.
block I'm in wichita and have a main bar setup for BBC. I thought Wiens was Springfield area. Mike Bruns 316-259-3883
summer bro we burned up a dist gear dry and ran a -3 oil line with jet drilled the smallest hole possible. Worked good after that.
conv I've run the bruno with a CS1 roots and screwblown. It's not that difficult but there's plenty of opinions. The bruno with a big pan is...
blower You'll pickup a lot with any high helix retro. IMO the blower is the closest thing to free hp you'll find. Even if you don't spin it hard...
