Separate names with a comma.
For 20 years we have been doing our own adaptor plates and tops of intakes with .125" o-ring by using a .125" endmill and going .115" deep. Be...
We run blown BBC's and mostly have offset rear mag drives but I'm slowing getting switched over to front mag drives. Does anyone sell premade to...
When comparing the crank align bore and the hole in the back of the bellhousing, what is an acceptable tolerance? Also, what are some different...
IMO its too much fuel. I agree with the above and when does your high speed open?
Check valve spring pressures. Close spark plug gap to around .016". Is it banging the blower, breaking the studs or raw fuel coming out the...
Are your installed height psi readings higher than what the box says they'll be? Mine normally are and than 1-3 runs later they are really close....
Years ago we shipped just our rotors to Andy and crew to save on shipping as we didn't want to ship all 3 blowers plus we saved on...
We have always used the .041" stainless wire that Clark Copper Head Gasket sells. Other places sell it too, I think Good Vibrations and RBS....
could call BME I beleive the instruction sheets that came with our BME rods said min .030", I'll try to remember to look tonight
We have always o-ringed our intake manifolds. How are these 2 different, such as, does a gasket get destroyed everytime the blower comes off?
My answer to sealing the cylinder psi is o-ring and receiving groove, also making sure the pistons aren't tapping the heads. I do not rely on...
My Performance Trends data logger exports to a spreadsheet if you so choose that option. Maybe yours can to?
I agree with the above, except for our T&D BBC rockers you have to use the real valve spring not a lightweight one. They build extra ratio into...
hmmm, haven't heard of this. The last 2 manifolds I machined flat and have had no problems.
We have a very similiar setup but in a cast iron Big M block. We have the BME 426 rod, it takes a fair amount of oil pan rail removal... I sent...
I have a vinyl decal auto-body shop right next door to me and was thinking of having them make me some butterfly decals like the lettering we...
We run the in fitting screen in the metering valve outlets for the hat and ports both.
http://www.rbssuperchargers.com/Products.cfm?pn=2600%2D0022O&pID=6551 This is what we have used for about 3 years. Oooops, I grabbed the oil...
ditto, exact same thought from me
Does anyone run aluminum brake discs? Have they been tried with hard coat anodizing and/or cryogenically treating them? What are the pros...
