Separate names with a comma.
I did flow the whole system and hindsight, since it was intermittent problem in the beginning, I happen to flow it when it we working fine. Keep...
Yes, flowed on a flowbench and its my bench and I did it :cool: Hindsight the problem was intermitent in the beginning, then became a probelm...
I know on hydraulic gear pumps that I work with (at my real job), if you suck air it can ruin the pump, I wonder if this true on Enderle pumps?
What I do with my stuff (tractor pulling) is set them at about %70, then start it and lean until the throttle response suffers and richen a touch...
Pretty sure its not as I flow tested the 1st pump and it was going away so I changed it and have since changed it again. To all who have...
Do you have any ideas how a Mallory Supermag IV and a 2900A coil can make the engine seemingly leaner than it had been? Please, I'm open for...
Butch, try your PM again, I cleaned it out some
FYI, this same thing can happen in a square barrel valve
Thanks for the suggestions, I have checked the poppets and they are in correctly, also with doubling up the main pill. Both of these would richen...
Fuel System doesn't react to main pill changes I am looking for ideas. I have a proven blown alky fuel system that suddenly, without any known...
I pay no attention to rod ratio, IMO it has so little to do with HP its not worth an ounce of emphasis.
I was hoping you could elaborate on the recharging and the reliability. We have put hundreds of runs on SM IVs with no troubles. They don't go...
I don't know what heads your running but I will be surprised if you hit 2000 HP at 23 psi. If you truely think you'll hit 2000 HP I'll also be...
In my situation I can see this working, thanks
Where do I find this? autoparts store (google came up with nothing) What is it originally used for?
Do you have any tricks to get sheetmetal parts disassembled after they have been "glued" together with silicone, prybars, chisels, etc. just...
I'd say your front cylinders are too lean because they are getting more air from the blower from the location of the blower outlet (this is real...
I'm not sure about steel rods and 18 psi boost, I'm not saying it won't work I've just never attempted myself. Does the blower have a pie...
Good thing you didn't run a Buzzardcatcher! After sucking in a 3/8"x1" bolt and wrecking the really nice blower we went to screens. Since then...
First I'd figure out why those rod brgs went bad. I'm thinking they siezed, broke the rods, the rods hit the cam and sheared your cam drive...
