Separate names with a comma.
Anyone have a good formula for calculating what wheelspeed should be after a rear gear change? I did a search and seen that Canter posted some...
What is the difference between a floater with 6 cutters and 3 cutters? Does the 6 cutter shave more disc material making the clutch act softer for...
Looking at a Hadman car and it has adjustable rear end plates that looks like the ride ride height can be changed. Are there different front/mid...
I have an old cast Hemi KB block with standard cam location and standard cam bore, does anyone know off hand the maximum amount of stroke the...
Is anyone running a billet throwout bearing fork in a blown alcohol deal? Is it worth the extra money? Is it primarily used for lockup clutches?
Clutch rub plate How much clearance is needed between the back of the flywheel and the mid plate rub block? We are running an aluminum flywheel,...
WTB Bonifante 10" clutch disc with 1 3/8 spline. Looking for .320 or thicker. Also looking for a triple disc clutch alignment tool 1 3/8-10...
For those of you running solid drive shafts with a Greek type coupler, how much end play do you have in the coupler system? What is the minimum?...
What are you guys using to glue in the magnet on the input shaft for the data recorder? Thanks.
Anyone using the aluminum clutch drum in a screw blown funny car/dragster or do I need the steel drum? Thanks.
Anyone ever run one of these? How is the durability of the compound gearset? Are all the parts the same in the reverser (shafts, planet assembly,...
Great job on your win! Jr, TJ, Duke and Reds all that hard work is paying off; two finals in a row! See you guys in Virginia. Rob, Dan, and Bob
What type of wire are you guys using for stainless O-Ring wire in the head to help seal the combustion chamber? Where is a good place to buy?...
What are you guys using for a pressure switch to convert an air signal from the shift pod to an electic signal to trigger an electric lean out...
Just recently had one of the mains saddled in one of my blocks after breaking a crank and tearing up one of the mains. Is it common practice check...
Any one have flow data for various spring pressures on -8 check valves? Thanks.
Is there some sort of formula or rule of thumb for the fuel pump size to tank vent? I see that some of the screw blown promods have two vents.
How do you guys have you accumulator plumbed and activated? Do you just use it as a reservoir and leave it open all the time? Do you use it to...
Can any one identify these lifters? There are no markings on them anywhere. Thanks. [IMG]
What is the maximum allowable leakage for an Enderle fuel shutoff? Just curious at what point a rebuild is necessary. Thanks.
