Separate names with a comma.
Does somebody make a square plug to put in the fuel heads if you take the down nozzles and fuel rails out? ...or is a mill and some silicone...
Does anybody run a 20w-50 synthetic w/ a hemi combo??? ...or is that a little on the thin side? Running a 526kb, brad fuel heads, 1471 25% over,...
Decreasing Power from a Hemi :eek:Hey guys! Finally bought a hemi for my Outlaw 10.5 car. :D Our main concern is obviously over powering the...
So which valve is better...stainless or titanium valves??? I run titanium in both exhaust and intake. On the dyno we burnt an exhaust valve...
Hey all! Getting ready to take our blown/alky small block ford to the engine dyno. We ran it in the car first to make sure all was well. We...
Anyone ever moved their barrel valve (K valve) to a remote location because of clearance issues and ran it using a cable?? Just curious, almost...
what's the name of the oil from caterpiller used in the bruno's??? Josh
Hey all...I run a blown alky small block ford. We're going to get the heads and block o-ringed (double o-ring, one in the block, one in the head,...
Hey guys....what advice would you give for someone wanting to get into the hemi world. What's a good starting point as far as what to look for...
Hey guys! I run Outlaw 10.5 w/ a blown alky SBF. Kind of an unusual question, but our fuel cell up front is too small (4 gal) so we put our...
This probably isn't the best site for this question...especially since i'm a trader and went to a procharger :D but does anyone know where to...
Hey guys...the last couple of years i've been running NGK's R5671A-9 plug I believe it is...this year I was told to change to an NGK B9ES because...
Anyone know someone who sells an offset mag drive for a small block ford reasonably? I know i'm asking a lot, but what about a sheet metal...
Hey guys I just want to see if I’m missing something. Got a outlaw 10.5 3350lb mustang, blown alky SBF 427ci, stripped roots 871 21%OD, 10.8:1...
Last year we ran some heads that flowed roughly 300cfm per chamber @750 lift on the intake. 408 sbf blown alky w/871 blower 9% od making 21lbs of...
Hey what do you guys use for marking your wheelie bars? I've used the geddex mark up and had no luck, just stayed on. Then I tried chalk, but it...
When you check alcohol, what do you do when you find the specific gravity? I assume you take that number and times it by what water weighs to...
Hey guys I’m confused and probably missing something really simple! I run a blown alky 427 ci, 10.8:1, 22lbs of boost, injected w/ .045’s in the...
Just wanted to know what some of you guys do after a race to lube the cylinders up. We had to bore our block (dart iron) last year because we...
Hey guys...need some opinions. I run outlaw 10.5 w/ a 427 small block ford, stripped 871, 8% over, 22lbs boost, injected alky. I was running...
