Separate names with a comma.
Anybody know of anyone in the midwest that can line-bore the camshaft...it's a KB Stage 10 block so it has the small bearing in the very back,...
Hey Guys...I know alot of you are running the pump relief ck valve line back to the hat instead of back to the tank. I was curious if any of you...
We're running a KB stage 10, standard deck (i think, 10.850"), raised cam block, BAE Fuel heads, Dechellis stands, Stage V intake arms (1.6),...
I'm still old school and run levers on my 3 sp lenco. I'm curious what guys use as far as lenco lever switches. IE-wanting to pull timing out...
We have a KB526 w/ BAE Fuel heads. We bought the motor complete and since then have torn it down to inspect, etc. The problem we're having is...
I'd seen a post a while back where someone was talking about using their accumulator to pre-lube the motor before starting. I was just curious...
Anyone had luck creating/buying an industrial type flow meter and hooking it up to your data logger? For $1000 bucks I can think of a lot of...
Who do you all use to get throttle or fuel shutoff cables made?
Any of you experimenting w/ running O2's on your blown alcohol setup?? Just curious how it's been working and what system beside's innovate's...
Anyone have any experience or know someone that ran MSD's 75611 Programmable Launch Rev Control? We're runnin Outlaw 10.5 w/ a blown hemi. We...
We're running a blown alky 526 KB w/ BAE fuel heads, 1471hh retro 25 over. We have a set of Moly Akerly&Childs rings. I called and they said the...
Do most of you all run some kind of lock on your fuel shutoff handle to ensure it won't start to close on a run? I haven't personally seen anyone...
Hey guys...i'm running a Big & Ugly injector that's going on a 1471 littlefield hi helix w/ the large opening...i believe it's 16" bolt pattern....
I know this subject has been wore out...but I've heard of guys running a Promag 20 and switching to a Promag 44, after they run the 44 for a while...
Hello! We're running a 3100lb outlaw 10.5 car w/ a kb 526 fuel headed hemi, 1471 hi helix, 30 over. We're running 33x10.5x16w on 16x16 double...
What's BAE's phone #? Do they have a website? I can't seem to find it. Thanks...
Who do you guys use to freshin/rebuild a 14-71? I'm in the midwest someone closer than the west coast would be nice...:rolleyes:
What's the best way to tell if you have Titanium or Stainless Valves or valve springs? Isn't stainless slightly magnetic?
What do you guys usually do w/ rods and pistons that have 10-20 passes on them. Is it worth sending them back to GRP and getting checked then...
Where's the best place to buy Hemi mid and front plates?? I need a mid plate that has chevy bell bolt pattern for a bruno. Doc Enterprises seems...
