Separate names with a comma.
Didn't see them in the first round of qualifying .
I do remember seeing a twin engine big block tad on n20 at columbus in the late 80's .
Most sell these fairly cheap under 30 bucks .
www.clippard.com , possibly part # mjv-3 . This is used to activate some fuel management systems , when you lift off the pedal it will exhaust ....
I think you might be talking about Wayne Morris , he used to run TAD and now runs AFC .
Torque convertor slippage . Might be a good one for Will to comment on also .
One has to be careful when speeding up a roots blower , especially if it is set up to run at lower OD speeds (not saying this is the case here) ....
If you are talking about these heads http://www.alanjohnson.com/Flyers/musclehead-flyer-back3.jpg , the only thing that will fit from your current...
On my D and F rotor the gears and rotors have a - mark on them that line up , kind of hard to mess them up but anything is possible . These might...
Dave Leahy at www.electrimotion.com works on them .
Please list the probs that that those have said they had with the MSD20 amp mags , I am just curious . Been hearing it for years and our 20 amp...
Leahy will also service mallory mags .
Thanks ! .
Kens # 216-390-4561 .
Looking for Veney's shop phone # .
Here is Ken Juszczyk's phone # for the Pac springs , 216-390-4561 . Ken is the east coast distributor .
I bought a new century a few years back and would buy another if I was in the market for one , I got the 1/2" head studs and .904 lifters bores...
Dean , you might want to double check the rules section on the PTO site , I don't see any of the dragsters being allowed to run a screw blower if...
I have seen a past world champs pro mod engine apart and he had 2 nozzles in the top and 1 from underneath in the intake .
Was paying $2.25 in the spring and at the end of the season most local places were around $ 4.00 a gallon . ( Ohio )
