Separate names with a comma.
Can someone tell me what my approximate fuel pressure should be with a .900 gear lil bertha with a total area for nozzles at .040345 and a total...
Does anyone know the weight of a PSI Deep Throat with the lip? I'm trying to see if it is worth the weight to move to a carbon fiber hat. Thanks
My clutch weight kit is all 1/4 stuff. Just bought a 10.7 Crower an it has 5/16 holes in the levers for counterweight. I'm guessing I should...
We are just getting our Brad back together. Wanted to crank it with a blower starter to check it out. We have not put the clutch or flywheel on...
Just got our PSI screw blower mounted on our BAE 5 hemi. When we turn the motor clockwise (looking at the front of the blower) the belt wants...
On a Brad Hemi with a RCD Fuel pump extension, what is the largest 14mm pulley you can fit on the bottom? It appears that we have just over 4 in...
Does anyone know what the intake and exhaust rockers ratios are on Brad 5 RED Stands Standard?
I see that MSD has discontinued the 8993 Top Fuel Tester. I was told that the 8998 (MSD's standard Ingnition, not Pro Mag) tester would work on...
We are running BAE Stage 5 Heads with BAE 5 rockers. The number 2 intake rocker adjuster keeps being beat up against the push rod cup area. It's...
I was looking for someone local to grind some disc and floaters for me. Anyone know of someone around Greensboro that could do it for me on short...
I know weight is weight, but do you guys balance the nuts and washers so that the weight is equal on both sides of the bolt in the finger? I...
Has anyone cut the bottoms out of their spark plug tubes where the plug would contact the head, instead of the tube? I can see some advantages,...
I am looking for the seal number for the rear seal on a CS1. It looks like it has 3897 stamped on the old one. Hopefully, I can get the correct...
After seeing Chris Russo's Weld Alumastar center break, I checked my centers. I understand that they make a "severe duty" center now. Therefore,...
I was looking at the Lenco clutch disk for a CS1 and was wondering if this was a disk out of some type of OEM automatic that Lenco just uses....
Does anyone have any experience with the Enderle Big and Ugly hat on the dyno vs a cardon fiber hat? I have not seen anything on how good the...
I ended up with a Bull Racing 10in 3 disk 6 small stand clutch. Bull Racing has since went out of business. I was told that it was design around...
Does anyone know what psi it takes to pop a SFI approved burst plate?
We run the M soft rod bearings. We made two passes on new bearings. Tune up was 26 degrees on a BAE Fat Head. Good runs, plugs look fine all...
I run a Set of BAE 5s with Stage V rockers. Will the Wizard's #7028 Valve Spring Checker work for testing the springs on the assembled heads?...
