Separate names with a comma.
Ok guys, first I would like to say thanks for the help and advice already given. I have been hot rodding for years, but my learning curve has been...
Listening Understand the total volume is higher at bottom of stroke and therefore compression is up with same chamber CC at the top....
I know this is in the wrong place, I followed the directions and even sent a private message in. I may have done it wrong and I also know lots...
Ooppps The cylinder was poured with the 4.25 crankshaft, I measured wrong with rod length (math in public). I will get a stretch gauge,...
New Rods Dave, The rods were new and bought from a friend that is on here. There were not bearing prints and there were sealed in original...
Enderle 1380 Thanks, trying not to. I am also considering going Waterman pump from my 20.9 Enderle to hedge off any questions about the...
Yes, I'll be a checking and rechecking fool on this build. I have never missed like this on any of my other motors, what an expensive...
Thanks...... pressing on. will run alky soon.......
Motor is out, heads are off, I am going to have to own a total screw up Critical Mass, You hit on at least one huge piece...........
Timing Yes, split the difference from both sides, That is dead on.
Crank Change Yes, changed to 4.5 and a shorter rod. Went from 10 to the 10.87. We talked about timing in the past as I remember.....
System flowed and the pump number is at 4000 pump rpm. I can start with less timing and move it all around, all "fuel head" advice on this...
Yes, flowed by a professional. Came back safe and a little fat, have been leaning carefully. Need some gouge on timing, fuel head guys say 32...
See other thread 526, I put a better, more collected set of thought on the "is this the right rod" thread
I will be looking tomorrow, lots of family and friend stuff today.
44 Mag Yes, 44 mag. I am running off a trigger, set TDC with dial to make sure it is perfect. I did start it once off the mag, not phased...
Live in Southern Indiana. Yes, system flowed, Enderle 1380 20.9 gallon pump, 4 jets (.079 and .082) top. 8 port 66-80 with cylinder 6 heavy. .045...
New Bryant crank, new rods purchased from a friend. 4.310 bore, 4.5 stroke, fuel heads, C rotor at 1.88 over. rev limiter at 9900. Bradco 2...
I can't get a shitty old hemi to run for 4 seconds without some major issue. Two Fowler rods are in pieces all over my oil pan (destroyed)...
Ghostbusters!!!! JR at RBS is awesome and fast!!! He will get you set up.
