Separate names with a comma.
I know this is not a tech question but: My enclosed trailer is sitting in Rescue, CA (about 30 miles east of Sacramento). I am looking for...
I am looking at putting helmet shrouds on a funny car cage. Most I have seen are the titanium version. Who makes them? I have seen the 3 piece...
Just trying to get a sanity check on fuel pressure at idle, about 2200 RPM. Roots blown, fuel headed hemi on alcohol 990 Enderle Pump 15.8...
I was mocking up a TFX-96 in the chassis to route my plumbing and wiring. Where is the normal place to tap off of for oil pressure gauges and...
Has or does anyone make a stack injector setup for a standard deck 426 style hemi with 10 bolt fuel heads or BAE Fat Heads? Thanks Greg
I am putting together a new fat head hemi engine and getting ready to order a crank. Between the RCD style splined snout and PSI splined snout...
I am looking for recomendations on who to contact for making a set a dragster style zoomies for a blown alcohol fathead motor. Thanks Greg
Who is the best source for fabricated aluminum valve covers for fat heads? Thanks Greg
In a blown alcohol 14-71 roots combination is a 120 degree rotor more efficient throughout the power band over a 60 degree rotor? Assuming you...
There have been several threads comparing the high end roots blowers, Kobelcos, PSI, DMPE, Littlefields, etc. I am familiar with the K8, K9, & K11...
What is the temperature at which the cad plating on the ring of the spark plug starts to discolor? I read this somewhere and can't remember where....
Some of you may already know this but I will pass it on anyway. In December 2008 CARB (California Air Resources Board) approved new regulations...
Pretty much all screw blower combinations I have seen use a pedal clutch or converter leaving at 4000 RPM plus. Has anyone tried using a screw...
