Separate names with a comma.
What kind of peak torque are the best blown alky engines making? 2000 ft lbs?
I agree with the above and will add. Once we had a hub crack and then weld itself to crank. I've heard of clutch vibration troubles causing...
Approximately how wide is the pan rail on a minor, more then 11"?
We have 1 of his pans on a Big M also. Ours has an o-ring on the long sides & I simply silicone the front & rear. It gos on & off well. I had fit...
If that collector is too small, I would believe that switching to zoomies could lean the engine, but I've never done it or helped anybody to do this.
I would not advance the timing more than that. What did the weather do between Bristol and Columbus? I bet your piston damage was started...
Keep your ignition timing in the low 30's and don't lean it out, it should be reliable. We're tractor pullers with Chevys (much lighter...
Less timing
IMO you want the smaller chamber, assuming the cfm is not hurt. If you don't run much of a dome anyway it probably doesn't matter. I'm...
Ours is about 3/16" and when screwed all the way in, its bottomed out.
I have run the Enderle pumps that high for many years, but I wouldn't go higher.
Could it be that a grease/oil film is getting on to the spark plug porcelain. This would give a electrical path to get to ground. Maybe the...
http://www.sassyengines.com/mallorymagnetorotorlg.jpg I found this pic showing Sassy's, I built my own but same diff... Dad would set our...
Do you use a beam style torque wrench to preload the rotor? this takes most of the "feel" out of the equation.
I like the buzz box but I'm setup & comfortable with it now, the first time I used it I hated it. Now I can set/check the timing without using...
Timing light is fine, I like a buzz box. 31-34°
Was it a NA truck or supercharged truck?
In my experience that has been too much, 31-34 is likely where the dyno would tell you to be.
Anyone built intake manifolds from carbon fiber?
What does the bolt hole pattern measure on that? I'm looking for dimensions E & D on this for the wider/newer bolt pattern...
