Separate names with a comma.
That would be a new one on me too.
3.80's Jody, You have a PM. Thanks
What Gear Ratio? Somebody will probably slap me, but I would think that having one "best" rear gear ratio for both 1/8 and 1/4 mile would be hard...
Breather Hose I had tried the lay flat hose, too but it does not stay open and did not let the engine breathe enough. It would open if the engine...
Starter Problems Shearing teeth I run a 168 chevy tooth ring gear with my Crower three disk pedal clutch on a 526 Brad hemi, 12.4...
Blower Sneezing I understand but I do not think it matters so much as to how many seconds into the run that you open the throttle as much as...
Dyno Sneezing Off the top of my head, I would say that is is likely to be a too lean condition at idle and not having enough fuel in the...
Scammers Still Looking For Suckers A couple of weeks ago I posted a want to buy ad here on ITA, looking for one or more new sets of hemi 1"...
16V starter amps Sounds like the same issues I faced a few years ago. That is exactly why I went to a 24 volt start system, using 2 12 volt...
High Pressure Air You might want to think about a single tank with the required regulators connected to the tank instead of more than one...
Surge Problems I could be wrong but it sounds to me more like a fuel delivery problem. Either the pump does not flow enough fuel because it...
Motor plate tabs I have used some bent chrome moly motor tabs from The Chassis Shop . Tab #C73-201 and I added a second 1/8" plate to the face...
Morel Lifter Sources I just bought some new sets of 1" Cranes, but during the process of finding what I wanted I was told from several...
Marty Check your message box. I am looking for a set of new 1" lifters for a hemi. Thanks
Crankshaft Specialists Not Specialities I had a bad experience from Crankshaft Specialists in memphis also. There is another company named...
MSD Kill Switch I installed the MSD 8134 for the kill solenoid when I installed my mag. It works fine. I also kill the power to the 8973 at...
24V Start Schematics I am posting the photobucket link for the 12V to 24V Starter wiring. Hope this helps....
24V Starter Wiring Hello Bic, I only use the solenoids because I want to be able to charge both batteries at the same time with a single...
24V Start Wiring Hey Clayton, I sent the schematics and battery information by email to you. Thanks
24V wiring Diagram Sent Hey Pete, I emailed you the schematics. Let me know if they do not make it to you. Thanks
