Separate names with a comma.
VIN Stamping I suppose that you received the correct title from the guy you bought the trailer from. If that title has a VIN number, you...
I second that motion. I think the motor is finding air somewhere you might not know about. Out of round injector blades or something else. My 526...
Sticking Lifters If the lifter body is what is "sticking" you might check the clearance in the lifter bore with the block warm. Sounds like...
What They Want To Hear Well said, Will. A lot of different opinions out there.
Possible Lean Out Conditions True enough, unless there is a piece of grit floating/rolling around inside ONE nozzle that might cause ONE...
Fuel Cut-off vibrating closed I had the same thing happen several times before I figured it out, too. I added an overcenter spring to hold...
Burst Panels and Belt problem X2 but check for clogged nozzles, restricted or collapsed fuel lines to the nozzles and/or a stuck open high...
Drive Extension Welding Maybe it's just me, but it seems to me that unless your machining and welding skills can produce a finished hex drive...
Throttle Sticking Open x2, bad cable or over center or weak return spring, but not freezing stuck open.
Hellfire Rings X2, I have had good luck with them, also. I have had not so good luck with anything stainless or plated or chromed. Just my...
Second Pill and Percentage I am certainly not qualified to answer those questions you posed. My tune-up is so far out in left field that the...
Mike at Rage convo about orifice constant Ok, the verdict is in. A. Mike at Rage said that a .109 orifice would flow close to 3 gpm (2.98...
Irifice Constant Ozrace, The 3 gallon number I mentioned was to be at the full 150 psi. Actually, changing ANY orifice in the system affects...
Orifice Constant I am trying to lose 3 gpm at 150 psi. I wanted to be sure of the constant number to be reasonably sure that the flow numbers...
Main Pill Fuel Flow Direction I understand that the flow is from the smooth side. I used the bevel and slotted description to describe the...
Orifice Constant I see that I left off some important info about my particular uses for the pump calc number. I am trying to calculate how...
I have been using the Pump Calcs orifice flow calculator online but I am not sure which "Orifice Constant" number I should be using for alcohol....
New Guys? 12 hours has not even gone by since your original post and you already have an attitude? Most of the posters on here are VERY...
13.9 Belt I have a new unused 13.9 belt from RCD in the 75 width and a 31, 34 and 39 pulley I'd like to sell as a package. $200 + shipping...
Pack Clearance Actually, I am running a 3 disk pedal clutch. Thanks
