Separate names with a comma.
The NHRA issued the release about allowing electronic timers to control pneumatic fuel system valves. The 8973 or 8971 gives a 12 volt signal...
The new PSI manual shows the slot being different for funny's versus dragsters. Is this the case? Way back when we had ours modified there was...
I am curious what size fuel line to run on a PSI BAE alcohol engine. The waterman bolt on shut off valve has a -10 outlet and my barrell valve has...
Looking for some tail light decals for the 97-99 camaro's. Ours were painted on, but we are having some spots fixed on the body and will be...
I had my PSI machined on top so there is not a groove for an 0-ring. Taylor doesn't make a restraint plate with an o-ring groove. Can I just seal...
Anyone know of any fall or early spring testing dates? Early this year there were Valedosta, GA and San Antonio testing days. When do these come...
I looked in the National Dragster, but didn't see a contact. Does anyone know a contact for Roush? C
I'va had a PSI system flowed and have imput it into Davenports Jet-Size program. If I decide to go to a larger/smaller pump, can I simply plug in...
I called and talked to Lenco, and they said the housing is a little bigger than the CS1, they have the same sprags, but the CS2 gear sets are a...
We are installing a low gear leanout on a PSI Dragster setup. Will plumbing the return back into one of the ports in the bottom of the pump hurt...
I have seen teams change to thicker or thinner head gaskets between runs. I am curious what they are trying to do that changing tranny ratio's &...
I bought a used CS2 Lenco transmission. It is said to have a 1.64 first gear ratio. When I pull it apart, how do I tell what gear ratios I...
I have seen several teams use a cap with a hole in it to "phase in the Mag". What is the purpose of this? C
I am new to the 3 disc clutch deal. I have searched in the tech area for other clutch articles and info but couldn't find any. Psi/Hemi BAD 10"...
