Separate names with a comma.
Say guys I am in need for some screw in KB offset dowels for my Hemi and titanium can. Does anyone make them. I cant find any. Will know offset...
Where can I get quick jet area chart to figure my jet areas quicker.
Does anyone make a nice threadable air bleed, preferably adjustable? and where to get them.
Anyone have a good used 14 mm gt belt very little use I could buy cheap. probably a 1610 belt. for 34- 41 about 20.5" center to center length.
Anything i need to remember or be concerned with, settings... with a 12 amp msd mag. Timing plugs...
Any one know length belt or how many teeth i need for 36 and 44 tooth combination. Kb block stage IV heads 528cid hemi. k11 superman dmpe deal....
Just wanted everyone to know my previous resin repairs failed. But I finally got it. And West systems 105 resin and 205 hardener ( EPOXY ) did the...
who has the nicest Tdc tool to thread into a hemi with rod and return spring that will accept basic dial indicator. Any pics or links? Thanks guys.
Has anyone run Amsoil in there cars. And what are your thoughts. Any reason not too?
Rolling in some .001 tighter king main bearings. Wanting to know what torgue sequence you guys use. KB block with two cross bolts on each side of...
are you guys running screens in AN fittings in valve cover return lines? If so what screen size. I have a dry sump system and I am using -12s...
I'm a little concerned about oil pressure. I run a 5 stage missile dry sump pump with 14.6 quarts of brad Penn 70. At initial start up it pegs...
Where do you guys set tension on belts when engine is cold. Just want to make sure I'm not too tight. K11 kobelco deal.
I am thinking about switching to a rossler, lencodrive or Bruno. I need some feedback. I heard from one person that every rossler he knows of...
I've never done this but has anyone ever put a lenco in neutral and exited the car to adjust Bv ... or is this just a no no. Just curious.
Anyone like or dislike anything about them. Mine is 5 stage. Mike c ? Thanks
Anyone have spikes cell number I lost it. Thanks.
Any simple easy way to filter 70 weight brad penn after cook off alcohol in coffee pot.
Anyone know if iso polyester resin Is resistant to methanol for use re finishing carbon hat. Trying to close tolerance on butterfly's.
I have an anodized alum fuel cell that has a small pin hole in a difficult area to clean up and weld. In rear of car where very hard to remove....
