Separate names with a comma.
I'm Asking This For A Friend Who Runs A Oval Track Outlaw Modified Who Is Limited On C.r. And Camshaft Cid Etc. And Must Run Gas But Fuel...
What Is The Difference In A Kb Olds Block And A Rodeck Chevy Block Do They Use The Same Cylinder Heads, Crank etc.What Do They Have In Common?,...
I have a early lenco coarse spline 3 speed Transmission who is good at rebuilding them I have a few questions. I have never been into one and want...
Does Anybody Run A Mckinney Clutch Pedal Kit That Would Take A Picture And Send It To Me. I Have The Kit Man It Has Alot Of Parts And No...
I wanted opinions on this, We have a rodeck 526 with a 14/71 HH Roots blower and a lenco trans in a TA/FC. What would be a good RPM to launch on a...
Does anyone know what the rules are for the hold down straps for a TA/FC fuel tank thickness, width, material etc. Thanks
How far from the header flange at the cylinder head should the EGT sensors be located? Thanks
I Have Changed My Combo And We Need To Buy New Pulleys And Belts Just Wanting To Know Which Is The Best Belt To Run 13.9 -14mm- 8mm Etc On A 14/71...
Anybody had problems getting total seal gap-less rings to seat. Ran the engine on a dyno to break it in made 3 pulls and have about 15-18 percent...
I have a canton oil pan with all the trap doors and a windage tray. It has a plug to check oil capacity in the side ,at the bottom of the hole the...
I want to clean a blower bag anybody have thoughts about this and what is the best way to clean it also what to use on it? thanks
I Have Put A Cylinder Head Temperture Gauge On The Car. It's A Solid Block With Solid Heads On Alky What Range Should The Head Temps Run? Thanks
Hays 11inch disc and floaters Who has 11inch disc and floaters other than hays just looking who has the best deal thanks to all.
Is there much difference in the handling of the goodyear front tires vs the hoosiers. They have such different thread designs. Thanks
When you have a engine sitting around for awhile what is the best thing to use in the cylinders to keep them from rusting the engine has never...
What Is The Most Common Brand Of Pedal Clutch Used In A Ta/fc And What Size? Any Reason One Is Better Than The Next? Just Looking For Info, Thanks
Does anyone know of a place where you can get a helmet fresh air system installed, the helmet is almost new and dont want to have to buy another...
Merry Christmas And Long Smokey Burnouts To All Of You, Many Who Have Answered My Stupid Questions That I Have Asked Over The Years. I'm Just...
I'm sure I will catch crap about this question but I'm going to ask anyway. I have seen idler pulleys run on the inside of a blower belt pushing...
Has anybody found a good cleaner that will remove the black streaks that get on the sides of Trailers. Looking for something that wont hurt the...
