Separate names with a comma.
Please indulge my ignorance for another moment. I watched the PM's at the snowbirds very carefully, and most of the faster cars went impressively...
When we run too fat, it becomes quite sensitive to air changes when the air gets better. We found that when you get close on the tune up--like...
So, if I understand correctly, you are balancing the thrust angle created due to more grip on the left rear with an imposed thrust angle created...
In another thread I saw that Mike Canter mentioned rear steer as a way to adjust a car driving to one side. I didn't want to hijack that thread...
I am sorry I missed you. Which car was Adams? There were a lot of extremely cool PM's there with Manzo and Newberry helping a few. I only talked...
While walking through the pits at the Snowbirds in Bradenton last weekend, I noticed that almost all of the blown cars had nozzles mounted in the...
Unless the "Redline shockproof" is somehow different than other synthetics, you want to avoid it. Mark Williams will give you the rundown on...
We have an old school Littlefield manifold with a conventional open bottom 1471 blower. I wanted to set it back some to begin with but we have to...
I found that on pg 162 of Szabos book after reading your reply, thank you. There is a further reference (Adams, Tim G. SAE #84512) to the...
I managed to step on my unit this weekend and melted #2 plug,as well as blowing out the burst panel. :( I am familiar with the problem of the BBC...
I would agree that the rpm will be more consistent on the chip, but I would agree with Pete that the power level can still vary with the air and...
Up is correct, that way the oil slinging off of the ring gear is "pumped" into the pinion bearing area and is forced(more or less) to flow back...
Hi Casey, Keep in mind that while idling, and possibly on the two step, you are running on just the hat nozzles. Changing the port nozzles will...
What Mike said.
What I can tell you is chassis builders like MIller, Spitzer, Takash, Damron, and Racetech (whose E-names and addresses I do not know) all either...
I have seen the "X" both welded and floating in some very fast cars, and it should not create the problem of going to the right ( if I understand...
You want the "duraprene" gaskets sold by Transtar industries (as well as Dacco, WIT and others). Especially if you are using a cast aluminum pan,...
Anything but Kevlar. I have had nothing but trouble with Kevlar friction material in ANY type of high performance trans, and the data sheets I...
ATI and Coan are both superb pieces, and you would really be splitting hairs to try to say one was better than the other. My personal preference...
Hot EGT/ cold plug I have seen the same thing as Bruce has, and I have seen the opposite. A very hot plug with cold EGT on the same motor. After...
